User manual SHARP FU-60SE

[. . . ] The unit controls the ratio of Negative cluster ions and Positive cluster ions depending on the condition of the room. This mode is effective for reducing some airborne mold. It is said that plenty of Negative cluster ions exist in places such as waterfalls or forests in natural environment. In this operation mode, Negative cluster ions will be released in an increased rate, in order to bring the room atmosphere close to this condition. [. . . ] In addition, periodically clean the wall, etc. When the cluster ion operation is in Clean mode or AUTO cluster ion mode and the air in the room is dirty, this light turns on and the unit will operate in Clean mode. When the cluster ion operation is in Ion control mode or AUTO cluster ion mode and the air in the room is clean, this light turns on and the unit will operate in Ion control mode. The light can be turned off by using the `DISPLAY ON/OFF button' on the remote control even while cluster ions are generated (Please turn off the lights when not required. Clean (green) Slightly dirty (orange) Very dirty (red) The sensor displays a CLEAN-SIGN lamp depending on relative changes to the environment from the time the power plug is inserted into the wall outlet and thereafter. ⷠWhen the air is extremely dirty at the time the power plug is inserted, the CLEAN-SIGN lamp may light green since the polluted state is the environment against which the sensor bases the pollution rate on. The CLEAN-SIGN lamp can be turned off using the "DISPLAY ON/ OFF" button of the remote control. MODE/ button See Page E-10 (Used to select operation modes or turn the unit off) Sensor sensitivity select switch the sensitivity of odor and dust detection can be adjusted. This setting is factory set to "Normal". Set the sensitivity to "High" if the sensitivity seems too low depending on the room condition. *Before pressing the Filter reset button, be sure to connect the power plug to a wall outlet. Detects dusts, smoke, pollen, house dust, etc. The output direction of the purified air can be changed to the directions indicated by the arrows. Fan level operation Model Power supply Fan level adjustment Rated power Fan level Applicable floor surface Cord length Dimensions Weight FU-60SE 220-240V / 50Hz Silent High Medium Max 4W 16 W 6W 53 W 43 m3/hour 197m3/hour 95m3/hour 360m3/hour ~46 m2* 2. * The applicable floor surface area is the surface area for when operating the unit in Max fan level. About the reduction of standby power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 0. For the conservation of energy, remove the power plug when not using the unit. Close the back cover The battery life is about 1 year. Take care of the following when handling: · When replacing the batteries, replace both batteries with new ones of the same type. When not using the unit or remote control for an extended period, remove the batteries. This prevents malfunction of the remote control from battery fluid leakage. *The batteries of the accessory are for initial use only and may be depleted within 1 year. [. . . ] After replacing filters, make sure to connect the power plug to a wall outlet, and press the filter Reset button on the main unit or on the remote control. (To maintain the best performance of this product, please clean the unit periodically. ) When cleaning, be sure to remove the power plug from the wall outlet. In addition, never handle the power plug with wet hands. [. . . ]