User manual SHARP FU-P60SE

[. . . ] Please read before operating your new Air Purifier The air purifier draws in room air from its air intake, lets the air pass through a Active Carbon Filter (deodorization filter) and a HEPA Filter (dust collection filter) inside of the unit, then discharges the air from its air outlet. The air purifier unit repeats this process by moving its internal fan. As air passes through, a new HEPA Filter can remove 99. The Active Carbon Filter gradually absorbs odour elements as they repeatedly pass through the filter. [. . . ] The unit will operate at HIGH* fan speed for 15 minutes, then will operate at Auto operation. The unit will operate at a fan speed of NORMAL. The unit will operate at HIGH* fan speed for 10 minutes, then will alternate between NORMAL and HIGH for 20 minutes. 10 minutes: HIGH fan speed 20 minutes: NORMAL fan speed 20 minutes: HIGH fan speed The unit will operate quietly using minimal air intake. * HIGH fan speed is an intermediate speed be tween NORMAL and MAX. When Plasmacluster Ion mode is ION AUTO or CLEAN mode, SENTINEL Operation is ready to be activated, and when SENTINEL Operation is in active, the Plasmacluster Indicator Light (blue) turns on and repeats its colour cycles between dark and light, and also the SENTINEL Operation Indicator Light (green) turns on. The "SENTINEL" function detects any air environment that is favourable for activation of mold, virus and allergen using its 4 sensors for dust, odour, temperature and humidity, and it releases Plasmacluster Ions to create an environment that controls the activity of airborne microbes. The fan speed and amount of Plasmacluster Ions are automatically increased during AUTO operation, while only the amount of Plasmacluster Ions is automatically increased during manual fan control mode and Pollen mode. When the Plasmacluster ion operation is in Clean Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is impure, the Plasmacluster ions will be released continuosly. When the Plasmacluster ion operation is in the Ion Control Mode, or in AUTO Plasmacluster Ion Mode and the air in the room is clean, this light will be activated and the unit will operate in Ion Control Mode. There are no Plasmacluster ions being generated. â· The light can be turned off by using the `LIGHTS ON/OFF Button' on the Remote Control. In this case, Plasmacluster ions are generated. (Please turn off the light when not required. The condition of the CLEAN-SIGN depends on the room air condition detected by the Dust and Odour Sensor when the plug is inserted into the wall outlet. â· It is possible to have a green CLEAN-SIGN with impurities in the air at the time that the air purifier was just introduced to the room environment. After a while, however, the base impurity rate will be adjusted to detect room air condition correctly. â· Use the Lights ON/OFF Button on the remote control to turn off the Indicator light. For the first 30 seconds after the power plug is inserted into the wall outlet, the unit will check the conditions of the air. If operation is set to ON during this time, the CLEAN-SIGN LIGHT will alternately flash in green, orange and red. Clean the Active Carbon Filter when the Filter Indicator Light is on. (The indicator light will be activated in about 2 months, when using the unit for 24 hours a day. [. . . ] Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. [. . . ]