User manual SHARP FZ-440SEF annexe 1

[. . . ] Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. *) Please contact your local authority for further details. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] Below are some simple ways to save energy when you use your air conditioner. sET THE CORRECT TEMPERATURE · Setting the thermostat 1°C higher than the desired temperature in the COOL mode and 2°C lower in the HEAT mode will save approximately 10 percent in power consumption. ⷠSetting the temperature lower than necessary during cooling operation will result in increased power consumption. bLOCK DIRECT SUNLIGHT AND PREVENT DRAFTS · Blocking direct sunlight during cooling operation will reduce power consumption. ⷠClose the windows and doors during cooling and heating operations. Pull the air filters down to remove them. The indoor unit still consumes a small amount of power when it is not operating. Use this mode when the remote control is not available. Push the arrow-marked of the panel firmly to lock it in place. The red OPERATION lamp ( ) on the unit will light and the unit will start operating in the AUTO mode. ⷠThe fan speed and temperature setting are set to AUTO. Is displayed for 5 seconds when the unit is not in operation. Manual adjustment of the open panel and the louvres can cause the unit to malfunction. The open panel will be set obliquely downward for 10 minutes, and then shift to obliquely upward to deliver cool air to the ceiling. The open panel will be set obliquely backward when outlet air temperature is low, and then shift to obliquely downward when outlet air becomes warm. When the room becomes warm, it will be set downward to deliver the warm air to the floor. When outlet air temperature is low The Plasmacluster Ion generator inside the air conditioner will release positive and negative plasmacluster ions into the room. Approximately the same numbers of positive and negative ions released into the air will reduce some airborne mold. SELF CLEAN operation will reduce the growth mold fungus with Plasmacluster ions and dry inside of the air conditioner unit. utilize the operation at seasonal change over terms. Mold fungus already grown can not be eliminated by this operation. The blue PLASMACLUSTER lamp on the unit will light up. [. . . ] Indoor fan will decrease its rotating speed and will turn ON and OFF depending on the room temperature. uNIT DOES NOT OPERATE IN YOUR REQUESTED MODE · When one indoor unit is operating in COOL or DRY mode, you can not operate the other unit in HEAT mode. When one indoor unit is operating in HEAT mode, you can not operate the other unit in COOL nor DRY mode. (After a few seconds , a long BEEP will be emitted , and the temperature indicator on the indicator panel will indicate" " and the OPERATION lamp and TIMER lamp will blink alternately. [. . . ]