User manual SHARP GX-X18JR

[. . . ] Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin!Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. [. . . ] After the above settings are completed, the "SAVE" will be displayed. the set temperature will not exceed the temperaturerangeoftheSAVEsetting. Forexample, the lower cooling limit is set to 23°C and the upper cooling limit is set to 27°C, so the cooling temperature can only be selected between 23°C to 27°C by the wire control or theremotecontroller. To cancel the SAVE setting, press the FAN and ( ) buttons for 5 seconds when the unit is turned off. The upper limit temperature should not be lower than the setting lower limit temperature. If upper limit temperature is lower than the lower limit temperature, the system will default the higher as the upper limit temperature, thelowerasthelowerlimittemperature. ⷠIftheupperlimittemperatureisthesameasthelower limit temperature, the system can only operate at this temperatureundercorrespondingmode. ⷠAfter the unit is disconnected to power supply, the SAVE settng will be memorized. The next time power on, theSAVEsettingisstillactive. Whentheunitisshutoff, presstheMODEbuttonfor0 seconds to switch set values so as to decide if the unit operating status or shut off status is memorized after a powerfail. If the set temperature area displays "0", it means the unit operating status or shut off status shall be memorized afterapowerfail;"02"meanstheoperatingstatusorshut off status will not be memorized. presstheON/OFFbuttontostorethesetvalueandexit thesetting. Even if the ON/OFF button is not pressed, the system will store the set value and exit the setting after 0 seconds, andreturntothenormalunitoffdisplay. The temperature can be set within the range of 16°C to 30°C. If room temperature is higher than set temperature, compressor and outdoor fan motor stop, onlyindoorfanmotorruns. ⷠThe temperature can be set within the range of 16°C to 30°C. If room temperature is between ±2°C of set temperature, air conditioner is drying. The temperature can be set within the range of 16°C to 30°C. When SLEEP operation is set during heating operation, the temperature setting drops 1°C in 1 hour and 2°C in 2 hours. Water may drop from the indoor unit when the humidity is over 80% or when the drainage outletisclogged. If anything is abnormal with the air conditioner (ex. If the unit appears to be malfunctioning, check the following points before calling for service. [. . . ] (If the unit is slant toward the opposite of the water flow, there may be malfunction of the float switch and lead water drop. When connect, smear both inside and outside of the flare nut with freeze motor oil, screw it by handandthentightenitwithspanner. The diameter of the drain hose should be equal or bigger than the connection pipe's. Drain hose should be short and falling gradient should more than /00 to prevent the formationofairbubble. [. . . ]