User manual SHARP HT-SB40_EN

[. . . ] ENGLISH MODEL Special Notes FCC Radiation Exposure Statement This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. It must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. [. . . ] To HDMI (TV ARC) input terminal Make sure to enable the HDMI CEC when making HDMI connection. For details, refer to the operation manual of the TV. Caution: ● Remove the battery if the sound bar will not be used for a long period of time. — Installing the battery incorrectly may cause the sound bar to malfunction. — Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: ● Replace the battery if the operating distance is reduced or if the operation becomes erratic. — Periodically clean the transmitter on the remote control and the sensor on the sound bar with a soft cloth. — Exposing the sensor on the sound bar to strong light may interfere with operation. Change the lighting or the direction of the sound bar. — Keep the remote control away from moisture, heat, shock, and vibrations. To turn the power on Press the ON/STAND-BY button on the sound bar or the remote control. — The power turns on and the subwoofer indicator turns blue. If the power does not turn on, check whether the AC power cord is plugged in properly. — The system will automatically power on if TV or similar component which supports HDMI CEC, is turned on. To set the sound bar to stand-by mode: Press the ON/STAND-BY button again on the main unit or the remote control and the subwoofer indicator turns red. Notes: ● A slight audio delay after TV is turned ON does not ● “AQUOS VCR DVD player Subwoofer To HDMI output terminal Place the system as shown. Remove the protective film covering the sound bar and subwoofer before turn on the system. to HDMI OUT (TV ARC) output terminal 2. Method 2 This connection is for HDMI TV without ARC (Audio Return Channel). Stand To HDMI input terminal To audio output terminal TV DVD, Blu-ray disc player or similar Sound Bar To HDMI input terminal Connecting a TV, or DVD player, etc. Connect to the TV using an optical digital cable or an audio cable. TV To audio output terminals System connections Make sure to unplug the AC power cord before making any connections. [. . . ] Subwoofer level control The subwoofer level can be adjusted. To decrease the level, press the SW LEVEL button. Notes: ● When sound from the speaker is distorted, decrease the subwoofer level. — When changing the subwoofer level, the output level of the subwoofer is also changed. [. . . ]