User manual SHARP HT-SB60

[. . . ] ENGLISH MODEL Special Notes FCC Radiation Exposure Statement This device complies with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. It must not be co-located or operating in conjunction with any other antenna or transmitter. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. [. . . ] For details, refer to the operation manual of the TV. Caution: ● Remove the battery if the sound bar will not be used for a long period of time. — Installing the battery incorrectly may cause the sound bar to malfunction. — Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like. Notes concerning use: ● Replace the battery if the operating distance is reduced To turn the power on Press the ON/STAND-BY button on the sound bar or the remote control. — The power turns on and the subwoofer indicator turns blue. If the power does not turn on, check whether the AC power cord is plugged in properly. — The system will automatically power on if TV or similar component which supports HDMI CEC, is turned on. To set the sound bar to stand-by mode: Press the ON/STAND-BY button again on the main unit or the remote control and the subwoofer indicator turns red. Notes: ● A slight audio delay after TV is turned ON does not mean that the system is faulty. — “AQUOS speaker is enabled” message will be displayed if SHARP LCD TV does not detect HT-SB60 during power on. However the message “AQUOS audio with AQUOS LINK is enabled” will be displayed soon as HT-SB60 is detected. These messages may vary for other TV model. vCR DVD player Subwoofer To HDMI (TV ARC) input terminal Place the system as shown. Remove the protective film covering the sound bar and subwoofer before turn on the system. to HDMI OUT (TV ARC) output terminal Stand To HDMI input terminal To HDMI output terminal Sound Bar Connecting a TV , or DVD player , etc. Connect to the TV using an optical digital cable or an audio cable. Method 2 This connection is for HDMI TV without ARC (Audio Return Channel). To HDMI input terminal TV To audio output terminal DVD, Blu-ray disc player or similar System connections Make sure to unplug the AC power cord before making any connections. Subwoofer To audio output terminals To Headphone terminal To HDMI output terminal or To HEADPHONE terminal Audio signal Blu-Ray/ DVD player/Digital Tuner Sound Bar Sound Bar To HDMI OUT (TV ARC) output terminal To HDMI input terminal To select HDMI 1, 2 or TV ARC function (Source): Press SOURCE button repeatedly until “HDMI 1”, “HDMI 2” or “TV ARC” appears on the display, or press TV ARC button on the remote control to select the TV ARC. Notes: ● This sound bar supports HDMI which enables ARC (Audio Return Channel). — To enable ARC make sure to use High Speed HDMI™ cable (with ARC). [. . . ] Notes: ● When sound from the speaker is distorted, decrease the subwoofer level. — When changing the subwoofer level, the output level of the subwoofer is also changed. Audio Return Channel (ARC) (Audio Return Channel submenu) The audio return channel (ARC) function enables an HDMI ARC-capable TV to send the audio stream to the HDMI OUT jack of the receiver. To use this function, you must select the TV ARC input and your TV must supports the ARC. [. . . ]