User manual SHARP IM-DR410E

[. . . ] IM-DR410E TINSE0550AWZZ 1 1-BIT PORTABLE MINIDISC RECORDER MODEL IM-DR410E OPERATION MANUAL If you require any advice or assistance regarding your Sharp product, please visit our web-site www. sharp. co. uk/customersupport. Customers without Internet access may telephone 08705 274277 during office hours (or (01) 676 0648 if telephoning from Ireland). 0101 Thank you for purchasing this SHARP product. For the best performance, read this manual carefully. It will guide you in operating your SHARP product. TINSE0550AWZZ 03G R YT 1 E IM-DR410E (TINSE0550AWZZ) IM-DR410E Special Notes ! [. . . ] Replace the alkaline battery with a new one. " When the battery has run out completely, "BATT EMPTY" will appear. Then, the power will be disconnected automatically. Notes: " The battery indicator will not correctly display the remaining capacity for approximately 10 seconds after the power has been turned on. " When the AC adaptor is used, the battery indicator will not be shown. " The number of bars shown in the battery indicator may increase or decrease, depending on the operation being performed. This is normal. -Checking Displays- When the battery level is high When the battery level is very low 5 6 5 4 3 2 1 Playing time 6 Press the MENU/ENTER button. 29 IM-DR410E TINSE0550AWZZ 03/7/21 IM-DR410E_4. fm IM-DR410E Titling a MiniDisc !Creating disc and track names Load a MiniDisc to be named. A playback only or recording prevented MiniDisc cannot be edited. 6 Press the button repeatedly to select the type of characters. 1 Advanced Features <Disc name> Whilst in the stop mode, press the MENU/ ENTER button. <Track name> Whilst in the pause mode, press the MENU/ ENTER button. (Capital letters) (Lower-case letters) (Numbers and symbols) 2 -Titling a MiniDisc- 3 4 Press the or button repeatedly to select "EDIT". Press the MENU/ENTER button. <Disc name> Press the or button repeatedly to select "DISC NAME". <Track name> Press the or button repeatedly to select "TRACK NAME". The first 3 characters in the group of the selected characters will be displayed for about 1 second. 7 Press the or lect the letter. button repeatedly to se- 8 Press the MENU/ENTER button to enter it. 5 Press the MENU/ENTER button. Position where the next letter will be entered Note: Complete the operation within 7 seconds whilst selecting the menus. Cursor " The unit will enter the character input mode. " To cancel the operation, press the :OFF/HOLD button. 30 IM-DR410E TINSE0550AWZZ 03/7/21 IM-DR410E_5. fm IM-DR410E 9 To enter more letters, repeat steps 6 - 8. 10When the name is completely entered, press and hold down the MENU/ENTER button for 2 seconds or more. " "TOC" will be displayed. To write the updated contents to the MiniDisc, press the :OFF/HOLD button. " You cannot remove the MiniDisc whilst "TOC" is displayed. "TOC" will not disappear until the recorded contents have been updated. !To erase a character Press the VOL + or VOL - button to move the cursor to the character you want to erase, and then press the BASS button. You can also erase a character by selecting "DL" and pressing the MENU/ENTER button. !To enter a space Press the VOL + button to move the cursor to the right. Advanced Features -Titling a MiniDisc- 6 !Characters (symbols) Capital letters D L Space I , J / j / !" #$%& >?@_ ` ' ( k l mn o pq r KLMNOPQR ABCDEFGH STUVWXYZ. Lower-case letters D L a t 1 b u c d e f y 6 / s D L vwx hi z. , 7 : g Numbers and symbols ) D L * 2345 +, . 890 ;<= Notes: " One disc name and up to 255 track names can be created per disc (a maximum of 40 characters for the disc and each track name and a total of about 1, 700 characters can be entered). [. . . ] There may be some deviations from these values in individual units. Power source: Power consumption: Output power: Dimensions: DC 3 V: AC adaptor (AC 110 - 240 V, 50/60 Hz) DC 1. 5 V: Commercially available, "AA" size (LR6), alkaline battery x 1 60 mA (AC adaptor) RMS: 16 mW (8 mW + 8 mW) (0. 2 % T. H. D. ) Width: 83 mm (3-9/32") Height: 28 mm (1-1/8") Depth: 76 mm (3") Excluding the projection around the USB connection terminal 117 g (0. 26 lbs. ) without battery Line/optical digital Earphones (impedance: 32 ohms) Portable MiniDisc recorder Non-contact, 3-beam semiconductor laser pickup Stereo 2 channels/monaural 1 channel 20 - 20, 000 Hz ( 3 dB) Approx. 400 - 2, 700 rpm CLV (Recording) ACIRC (Advanced Cross Interleave Reed-Solomon Code) ATRAC/ATRAC3 (Adaptive TRansform Acoustic Coding), 24-bit computed type Magnetic modulation overwrite method 44. 1 kHz (32 kHz and 48 kHz signals are converted to 44. 1 kHz, and then recorded. ) Unmeasurable (less than 0. 001 % W. peak) References -Specifications- Weight: Input socket: Output socket: Type: Signal readout: Audio channels: Frequency response: Rotation speed: Error correction: Coding: Recording method: Sampling frequency: Wow and flutter: 50 IM-DR410E TINSE0550AWZZ 03/7/21 IM-DR410E_6. fm IM-DR410E Battery life: Stereo When using a commercially Continuous available, high capacity, "AA" recording: size (LR6), alkaline battery Approx. [. . . ]