User manual SHARP JX-735

[. . . ] These can be re-used for transporting the machine, should it be necessary. 1 2 3 4 5 6 Original cover Original table Operation panel Paper output tray Front cover Paper tray 7 8 9 10 Paper guide Power switch Power cord socket Printer interfaces (JX-735 only) 11 Paper release lever 12 13 14 15 Drum cartridge Drum cartridge handle TD cartridge TD cartridge handle This copier has been designed to provide intuitive operating ease while requiring a minimum amount of space. To get full use of all copier features, be sure to familiarize yourself with this manual and the copier. For quick reference during copier use, keep this manual in a handy location. [. . . ] Drum cartridge life To find out how many more copies can be made before the 20, 000 marks is reached, follow the procedure described below. Press and hold down the light ({) and dark ( }) keys simultaneously for more than 5 seconds until all the alarm indicators (w, t, s ) blink and "­ ­" appears in the display. Press and hold down the clear (>) key for more than 5 seconds to find out how many more copies can be made. Example: 500 copies can be made before the next drum cartridge replacement. Proper care is essential in order to get clean, sharp copies. Be sure to take a few minutes to regularly clean the copier. Before cleaning, be sure to turn the power switch off and remove the power cord from the outlet. Do not use thinner, benzene or other volatile cleaning agents. Cabinet Wipe the cabinet with a soft, clean cloth. Original table and original cover Dirt or stains on the glass or cover will also be copied. Wipe the glass and the cover with a soft, clean cloth. If the misfed paper will not come out easily, do not pull it hard, as you may tear it or damage the printing mechanism. Straighten the edges of the stack of paper and then reinsert it into the paper tray. Push the paper release lever back again to secure the paper. Place some scrap paper on a nearby level surface. Push gently on both sides of the front cover to open the cover. Gently pull the TD cartridge out and place it on the scrap paper which was prepared in step 1. Take a piece of scrap paper that is larger than the drum cartridge and fold it in half. Keep this paper ready to shield the light-sensitive part of the drum cartridge from light after it is removed from the copier. The paper to be used for placing the TD cartridge and drum cartridge may be soiled due to toner, etc. The paper for placing the drum cartridge must be enough large to cover the surface of the cartridge (green portion) and must be foldable in half. Gently pull the drum cartridge out and wrap the removed drum cartridge in the paper which was prepared in step 5 so that the green drum section is shielded from light. [. . . ] Copy speed Continuous copying First-copy time Copy ratio Exposure system Copy paper feed Fusing system Development system Light source Resolution Gradation Power supply Power consumption Overall dimensions Weight Copier dimensions Operating conditions First-copy time may differ depending on operating conditions, such as power-supply voltage and room temperature. The values for copy speed are rounded to the nearest whole number. As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. the performance specification figures indicated are nominal values of production units. [. . . ]