User manual SHARP KC-860U

[. . . ] KC-860U AIR PURIFIER with Humidifying Function OPERATION MANUAL Purificateur d’air à fonction d’humidification MANUEL D’UTILISATION Con función de humidificación MANUAL DE OPERACIÓN Device of this mark is a trademark of Sharp Corporation. “Plasmacluster” and “Device of a cluster of grapes” are registered trademarks of Sharp Corpration in Japan , USA and elsewhere. This product earned the ENERGY STAR by meeting strict energy efficiency guidelines set by the US EPA. US EPA does not endorse any manufacturer claims of healthier indoor air from the use of this product. [. . . ] AUTO operation The fan speed is automatically switched (HIGH*, MEDIUM, LOW) depending on the amount of impurities in the air. The sensors detect the impurities for efficient air purification. POLLEN mode operation MAX operation MEDIUM operation LOW operation The unit will operate at High level for 10 minutes, then will alternated between MED and HIGH every 20 minutes. The unit will operate at maximun fan speed . The unit will operate at medium fan speed . The unit will operate quietly using minimal air intake. * HIGH fan speed is an intermediate speed between MEDIUM and MAX. Plasmacluster ON/OFF Button Press the Plasmacluster ON/OFF Button to turn Plasmacluster Ion Mode ON and OFF. When Plasmacluster is ON, both the Indicator Light and Plasmacluster Indicator Light on the front display turn on. POWER OFF Button Press the Power OFF Button to turn the unit off. Indd 13 OPERATION LIGHTS CONTROL Button Use when the light on the front panel is too bright. Refer to the diagram to select the desired brightness on the front panel. €｢ ｣  ｢ ｣  ｢ ｣ The lights on the front panel are brighter. The lights on the front panel are darker. The lights on the front monitor turn off. CAUTION The lights on the front monitor are always brighter when starting. WATER SUPPLY INDICATOR LIGHT When the Water Tank is empty, the Water Supply Indicator Light will flash to indicate that the Water Tank should be refilled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and the Quick Clean Mode. Sound indicator setting for water supply. In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty. With the unit OFF, press the Lights Control button for 3 seconds to turn the audible signal ON. Cancellation To cancel the audible signal, with the unit OFF, press the Lights Control button again more than 3 seconds. [. . . ] If so, then press the Lights Control Button to activate the indicator lights. Ensure unit is located on a level surface. Check to see if the Humidifying Tray and Water Tank are correctly installed. € Check to see if the Humidifying Tray and Water Tank are correctly installed. [. . . ]