User manual SHARP KC-930E

[. . . ] Please read before operating your new Air Purifier Some odour ingredients absorbed by the filter may become separated and may be discharged through the air outlet and result in additional odour. Depending on the usage environment, especially when the product is used in a condition significantly more severe than household use, this odour may become strong in a shorter period than expected. The air purifier is designed to remove air-suspended dust and odour, but not harmful gases (for example, carbon monoxide contained in cigarette smoke. ) If the odour sources still exist, it cannot completely remove the odour(for example, odours from construction materials and pet odours). [. . . ] The unit can be used in the Clean Air Mode without putting water in the Water Tank. When using in the Humidify Mode, the Water Tank should be filled with water. Remove the Water Tank Cap and carefully fill the Water Tank with tap water. Change the water in the Water Tank every day with fresh tap water. Be sure to wipe off any excess water on the outside of the Water Tank. When carrying the Water Tank, hold it with both hands so that the Water Tank opening is facing up. Short circuit and/or electrical shock may occur as a result. Do not use hot water (40 ºC), chemical agents, aromatic substances, dirty water, or other damaging substances, deformation and/or malfunction may occur. Use of other water sources may promote the growth of mold, fungus and/or bacteria. Please select either Humidify mode or Clean air mode operation when operation when using. Unless the power cord has been unplugged, the operations starts in the previous mode it was operated in. The unit will operate quietly using minimal air intake. The unit will operate at a fan speed of MAX. The unit will operate at a fan speed of MEDIUM. When Plasmacluster Ion is ON, the Plasmacluster Ion Indicator Light will turn on. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to first unplug the power cord, and never handle the plug with wet hands. After 720 hours of use (30days × 24hours = 720) The Indicator Light will turn on after approximately 720 hours of use. Even if the Filter Indicator Light is already off, the RESET button should be pressed to reset the maintenance timer. Whenever dust accumulates on the unit or every 2 months Gently remove dust from the sensor opening and the back panel, using a vacuum cleaner attachment or similar tool. In case of heavy dirt, soak the back panel in water with a small amount of kitchen detergent. ) (Avoid scrubbing the back panel hard when washing. [. . . ] Model Power supply Fan Speed Adjustment Fan Speed Rated Power operation Fan Speed Humidification Recommended Room Size High density Plasmacluster ion recommended room size Water tank capacity Sensor Filter type Cord Length Dimensions Weight MAX 27W 180m3/hour 350ml/hour KC-930E 220-240V 50/60Hz MED 13W 126m3/hour 250ml/hour ~21m2 *1 ~17m2 *2 2. *1 Size of a room which is appropriate for operating the unit at maximum fan speed. It indicates the space where a certain amount of dust particles can be removed in 30 minutes(JEM1467). *2 Size of a room in which approximately 7000 ions can be measured per cubic centimeter in the center of the room (at a height of approximately 1. [. . . ]