User manual SHARP KC-C150E

[. . . ] Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a Pre-Filter, a Washable Deodorizing Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet. The Washable Deodorizing Filter gradually absorbs odours as they pass through the filter. Some odours absorbed by the filters may break down over time, resulting in additional odour. Depending on the usage environment, especially when the product is used in extreme environments (significantly more severe than normal household use), this odour may become strong in a shorter period than expected. [. . . ] *HiGH fan speed is an intermediate speed between MEDIUM and MAX. Press this button to turn Front Panel monitor lights ON and OFF. When the Water Tank is empty, the Water Supply Indicator Light will flash to indicate that the Water Tank should be refilled. Please note the light will not flash even when the Water Tank is empty during the Clean Air Mode and the Clean ION SHOWER Mode. In addition to the Indicator Light, the unit can be set to signal with an audible beep when the Water Tank is empty. With the unit OFF, press the Lights ON/OFF button for 3 seconds to turn the audible signal ON. Cancellation To cancel the audible signal, with the unit OFF, press the Lights ON/OFF button again more than 3 seconds. With the unit OFF, press the Fan Speed Button for 3 seconds. Note that if the Power OFF Button is not pushed within 8 seconds of adjusting sensor sensitivity, the setting will be saved automatically. The sensor sensitivity setting will be saved even if the unit is unplugged. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to first unplug the power cord, and never handle the plug with wet hands. After 720 hours of use (30days ×24hours = 720 The Indicator Light will turn on after approximately 720 hours of use. after performing maintenance , reset the Filter Indicator. Plug the unit in, turn power ON, and press the RESET button for 3 seconds. the Filter Indicator Light will go off. Even if the filter indicator light is already off, the RESET button should be pressed to reset the maintenance timer. Care Cycle Whenever dust accumulates on the unit or every 2 months Gently remove dust from the sensor opening and the back panel, using a vacuum cleaner attachment or similar tool. Care Cycle Whenever dust accumulates on the unit or every 2 months To prevent dirt or stains on the unit, clean regularly. If stains are allowed to remain, they may become difficult to remove. Wipe with a dry, soft cloth Do not use volatile fluids Do not use detergents For stubborn stains or dirt, use a soft cloth dampened with warm water. Benzene, paint thinner, polishing powder, may damage the surface. [. . . ] Used electrical and electronic equipment must be treated separately and in accordance with legislation that requires proper treatment, recovery and recycling of used electrical and electronic equipment. Following the implementation by member states, private households within the EU states may return their used electrical and electronic equipment to designated collection facilities free of charge*. In some countries* your local retailer may also take back your old product free of charge if you purchase a similar new one. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ]