User manual SHARP LC-17SH1E

[. . . ] LC-17SH1E LCD COLOUR TELEVISION OPERATION MANUAL Introduction / Safety is Important Introduction Thank you for purchasing this product which has been designed and manufactured to give you many years of trouble-free service. You may already be familiar with using a similar product, but do please take time to read these instructions - they have been written to ensure you get the very best from your purchase. Safety is Important To ensure your safety and the safety of others, please ensure you read the Safety Instructions before you operate this product. Keep this information in a safe place for future reference. This apparatus complies with the requirements of Council Directives 89/336/EEC and 73/23/EEC as amended by Council Directive 93/68/EEC. SPECIAL NOTE FOR USERS IN THE U. K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 3A fuse. [. . . ] EXT1 (from 21 pin SCART socket on the rear left), EXT2 (from 21 pin SCART socket on the rear right), EXT3 (from Audio/Video in sockets on the left side) or PC (from PC IN socket on the left side) indicator appears on the screen in AV mode. -:6 (FLASH BACK) This button allows you to go back to the previous channel by pressing again to return to the channel you were watching. (FLASH BACK). Press this button DISPLAY When you press (DISPLAY) once, the channel number and screen picture size etc. The display will disappear in 4 seconds. MUTE When (MUTE) is pressed, the TV sound will be turned off completely. To disable this function, press the button again or @ + or ­. SLEEP To set the unit to turn off, press SLEEP on the remote control. The clock will count down 10 minutes each time the button is pressed in the order of 120, 110, 100, . . . 20, 10, 0. After the sleep time is programmed, the display will disappear and will reappear momentarily at every 10 minutes. To confirm the sleep time setting, press SLEEP once and the remaining time will be momentarily displayed. To cancel the sleep time, press SLEEP repeatedly until the display turns to 0. SKIP FUNCTION After all channels available in your area have been set in memory, you can skip unwanted channels as follows. to select the channel which you want to skip. When a channel is skipped, the channel number will blink. Skip all unwanted channels the same way following steps 1-2. Note: To cancel the SKIP function, press Direct Channel Selection buttons to select the channel which you want to cancel, then press SKIP again. 21 ON/OFF Timer The on timer feature allows you to automatically turn on your TV after a preset amount of time (up to 12 hours and 59 minutes) on the selected channel. The off timer also allows you to turn off your TV after a preset amount of time. You can set the off timer in conjunction with the on timer. Then press OK. ON TIMER OFF TIMER SET 00:00 SET 00:00 CH 1 : SELECT OK : SET MENU : RETURN 2. Press or to enter the hours and minutes at which you want your TV to automatically switch on. ON TIMER · For rapid time change in ten minute intervals, press and hold or . Press . OFF TIMER SET 10:30 SET 00:00 CH 1 : ADJUST OK : SET : SELECT MENU : RETURN 3. Press or to select the channel you wish to display when your TV switches on. Press OK. ON TIMER OFF TIMER SET 10:30 SET 00:00 CH 1 : ADJUST OK : SET : SELECT MENU : RETURN Put your TV into Standby mode by pressing If you wish to set the OFF TIMER, press or on the remote control. [. . . ] Operate within 7 metres and reduce the light of the room. PAGE 11 14 11 12 14 20 20 12 31 20 31 20 12 20 12 20 31 24 10 10 10 10 10 POWER No power. TV BROADCAST RECEPTION No picture, no sound. Sound OK, poor picture. Poor reception. Poor colour or no colour. REMOTE CONTROL It is not aimed at the remote sensor. Distance too far or there is too much light in the room. Polarities of the batteries, + or ­, are not inserted correctly. Remote control does not work. Specifications GENERAL Power supply: Power consumption: Weight: Dimensions: Operating temperature: Storage temperature: Operating humidity: TELEVISION Type: Display method: Number of Pixels: Viewing angle: Tuner type: Receiving channels: Aerial input: Speaker: Audio output power: ACCESSORIES: AC 220~240V 50/60Hz Operation : 45W / Stand by : 1. 6W 5. 5 kg (12. 1 lbs) without stand / 7. 0 kg (15. 4 lbs) 456 (W) x 385. 5 (H) x 70 (D) without stand / 456 (W) x 429. 5 (H) x 315 (D) mm 0°C to + 40°C -20°C to + 60°C Less than 80% 17" (434. 4 mm Visible) Transmission TFT colour LCD panel 1280 (H) x 768 (V) Left/Right : 88/88 degree / Up/Down : 88/88 degree Quartz PLL Frequency Synthesized VHF Low : E2~S6, VHF High : S7~S36, UHF : S37~E69 VHF/UHF In 75 ohm coaxial 38 mm x 69 mm, 16 ohms x 2 1. 5W + 1. 5W Remote control / Batteries (AA type) x 2 / AC adapter / AC cord Weight and Dimensions are approximate. [. . . ]