User manual SHARP LC-40SH340E

[. . . ] The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 5A fuse. Should or and of the same rating the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. [. . . ] You can select options by using " "/" " and OK buttons. In manual channel scan, the number of the multiplex or frequency are entered manually and only that multiplex or frequency are searched for the channels. After selecting search type as Digital Aerial, you can enter the multiplex or frequency number using the numeric buttons and press OK button to search. In cable manual scan, you can enter frequency, modulation, symbol rate and network channel scan options. After selecting search type as Digital Cable, you can set the desired options and press OK button to search. If you start Digital Cable scan process, the following screen will be displayed. After selecting search type as analogue, you can use " "/" " button to highlight an item and then press " " or " " button to set an option. Enter the channel number or frequency using the numeric buttons. When the channel is located, any new channels that are not on the list will be stored. You can select frequency ranges from this screen. For highlighting lines you see, use " " or " " button. You can enter the frequency range manually by using the numeric buttons on the remote control. set Start and Stop Frequency as desired by using numeric buttons on the remote control. After this operation, you can set Search Step as 8000 KHz or 1000 KHz. If you select 1000 KHz, the Tv will perform search process in a detailed way. Note: If you select an extended gap between Start and Stop frequency rate, automatic search duration will take a longer time. Select Analogue Fine Tune from the Installation menu by using " " or " " and OK buttons. analogue fine tune screen will be displayed. Analogue Fine Tune feature will not be available if there are no analogue channels, digital channels and external sources stored. Use this setting to clear channels stored. Select Network Channel Scan from the installation menu by using " " or " " and OK buttons. You can edit this channel list, set favourites or set active stations to be listed by using the Channel List options. [. . . ] So before software upgrade search, it is advised to auto search and update all available channels. It is possible manually to check if there is a new software upgrade for your TV set. â· Simply navigate on your main menu. If a new upgrade is found, it starts to download the upgrade. [. . . ]