User manual SHARP LC-43CFF5111E

[. . . ] верткой AAC EN  Important safety instructions CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Please, read these safety instructions and respect the following warnings before the appliance is operated: • To clean the screen of the appliance use only a damp and soft cloth. Use only clean water, never detergents and in no case use solvents. € Position the TV close to the wall to avoid the possibility of it falling when pushed. € Ensure that children do not climb or hang onto the TV. [. . . ] If the TV does not respond to remote control commands, follow the instructions below. Pairing the remote control unit (RCU): a) If the TV turns on automatically and the window "First Time Installation" found appeared on the screen, press and hold for a few seconds green and yellow buttons on the RCU. The power indicator will blink 5 times, that would confirm the pairing of TV and RCU completed. B) If the TV does not automatically turn on, you need to power it on by using of standby key allocated on the TV (but not on the RCU). After TV started up press once again a standby button, then there menu "Pair your remote" will appear. Scroll the cursor down using the buttons CH+/CH, to select "Pair your remote", and confirm it by pressing standby button one more time. Simultaneously press and hold for a few seconds green and yellow buttons on the RCU. The power indicator will blink 5 times, thus confirming the pairing of the TV and the remote control completed. Now proceed next steps to configuring the TV. After turning on the TV you will see the menu "First Time Installation". If the menu does not appear, You can recall it by pressing the remote control buttons "Menu", then 8-8-8-8, so this menu window would be re-opened. If you wish to make changes to any of the default settings, use the scroll ▲/▼/◄/► buttons. DVB Antenna - You can choose between Terrestrial (DVB-T/T2), Cable (DVB-C) or Satellite (DVB-S/S2)*. Tunning Mode - Choose if you want to tune only Digital (DTV)  1. Remote control Radio controlled remote control - No more aiming in the TV direction!Refer to remote control picture on the second page of this user manual. € To return to the previous channel viewed. CH ▲/▼ – To increase or decrease the channel being watched. (▲/▼/◄/►/ OK) – Allows you to navigate the on-screen menus and adjust the system settings to your preference. Press twice for programme information about current programme. SUBTITLE – To switch the dialogue at the bottom of the screen (on/ off ). ASPECT – To switch the screen between the different picture formats. [. . . ] To confirm the item you wish to play/view press [OK] button. (If your drive only has 1 partition you will only see 1 item). While viewing you may control the item playback modes by using the remote control buttons or by invoking playback navigation menu and selecting on-screen buttons ▲/▼/◄/► and [OK] NOTE: USB extension cables are not recommended as they can cause a reduction in picture/audio quality and stoppages during play back of USB content. ς USB Record - Digital mode Built into this television is a USB record facility. [. . . ]