User manual SHARP LC12A2E QUICK START GUIDE

[. . . ] [. . . ] Make sure the antenna cable is properly connected. Rear control panel of main unit 1 Press MENU on the main unit for more than 2 seconds. The AUTO mode screen appears. AUTO( ) VHF 1 43. 25MHz 2 Press VOL (­) on the main unit. All the TV stations in your area that can be received by the LCD TV set are automatically preset between channels 1 to 99. VOL (­) MENU 3 The screen shows whatever is on channel 1 when fully automatic channel preset is finished. PAL 1 Presetting the Channels (MANUAL) I Setting a channel number for desired TV station Rear control panel of main unit 1 2 Press MENU on the main unit for more than 2 seconds. The AUTO mode screen appears. Press MENU until the MANUAL mode screen appears. MANUAL( ) VHF 1 48. 25MHz VOL (+)/(­) MENU Web-site: www. sharp. co. uk/support Help Line (office hours only): 0990-274277 LC-12A2EGuide 3 00. 8. 5, 5:17 PM Presetting the Channels (MANUAL) (Continued) 3 Select the channel number with CHANNEL SELECT or CH (L)/(M). MANUAL( ) VHF 5 107. 50MHz Channel number 4 Press VOL (+)/(­) to locate the station you want to preset to the channel. A search is initiated and when a TV signal is received during the search, the search stops. 5 6 Rear control panel of main unit Repeat steps 3 and 4 above to preset the channel numbers for other stations. Press MENU until the normal screen appears. I In a weak reception area, or under bad reception conditions 1 2 3 Press MENU on the main unit for more than 2 seconds. The AUTO mode screen appears. Press MENU until the MANUAL mode screen appears. While the MANUAL mode screen is displayed, press MENU for more than 2 seconds to display the FINE mode screen. The channel number remains in green. VOL (+)/(­) MENU FINE UHF 5 625. 50MHz 4 5 Adjust for good reception with VOL (+)/(­). [. . . ] [. . . ]