User manual SHARP LC13-B2E

[. . . ] This equipment complies with the requirements of Directive 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 3A fuse. Or and of Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. [. . . ] When selecting the channel using Channel Select, finish inputting the channel number by holding down the button for the last digit for a moment. After the search is completed, press END to exit. Press ]/[ to select the item, and then press </> to make the adjustment. You can also use Channel Select to adjust the "Channel" and "Frequency" items. If you press YELLOW, all subsequent programmes including the marked one move one programme position back. When YELLOW is pressed, a free programme position is inserted at the current cursor position. If you want to erase programmes in a connected range, select the programme at the beginning of the desired range. Press OK to accept the name entered, and then press END to exit. Note: I See page 29 for information on how to use the "Decoder programmes" item. Repeat the same procedure if you want to specify other decoder programmes. Press ]/[ to select "Sound from AV1", and then press </> to select the desired sound source. 196 The influence of the AV control voltage and of fast blank at programme positions from 1 to 196 can be set. Notes: I If the item concerned is set to "yes", the appropriate picture is through-connected at all programme positions from 1 to 196 when a control voltage/an RGB signal is applied. The Child Lock function blocks the viewing of any channel for which the child lock has been set. To use the Child Lock function, you first need to define your PIN (Personal Identification Number). Notes: I Be sure to make a note of your PIN before pressing OK. I The PIN will not be set if MENU or END is pressed before the fourth digit has been input. Notes: I Numbers entered are hidden with ?| In step 3 above, press ]/[ to [3] Setting Child Lock There are four different ways of activating a child lock: 1. General child lock for all programmes immediately 2. General child lock for all programmes with daily time limit 3. General child lock for all programmes with single time limit 4. [. . . ] Make sure the remote sensor window is not under strong lighting. Make sure the antenna is facing the correct direction. Make sure the outside antenna has not been disconnected. Make sure the antenna is facing the correct direction. [. . . ]