User manual SHARP LC40FG3242E

[. . . ] The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 13A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or ASA and of the same rating as above, which is also indicated on the pin face of the plug, must be used. Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted. [. . . ] € The minimum setting cannot be set to a bigger number than the maximum setting. € The maximum and minimum settings cannot be set to the same number. € Depending on the brightness of the surrounding light, the OPC sensor might not operate if the adjustment range is small. Film mode Automatically detects a film-based source (originally encoded at 24 or 25 frames per second, depending on the vertical frequency), analyses it and then recreates each still film frame for high-definition picture quality (“Advanced (High)”, “Advanced (Low)”, “Standard”, “Off”). Each time you press #, the mode changes. € You can also switch the mode on the “Picture” and “Audio” menu screen by pressing #. You can set the mode for each input source. For a clear-cut image emphasising high contrast for sports viewing (the “Picture” and “Audio” settings cannot be adjusted). For a clear-cut image emphasising high contrast for sports viewing. The TV automatically sets the appropriate selection from the “AV MODE” menu depending on the lighting conditions and the type of programme watched. NOTE • This function may not be available depending on the input signal type. 3D-Y/C DYNAMIC (Fixed) Provides high quality images with minimal dot crawl and cross colour noise by detecting changes in the image. item Standard Fast Slow Normal adjustment. Sets the optimum image quality for fastmoving images. Sets the optimum image quality for slow-moving images. AUTO DYNAMIC NOTE NOTE • “3D-Y/C” may not operate depending on the input signal type or when the input signal is noisy. • “3D-Y/C” has even more effect on composite video signals (CVBS). € The item marked with * is available only when selecting “HDMI 1”, “HDMI 2”, “HDMI 3”, “HDMI 4” or “EXT 4” from the “INPUT SOURCE” menu. € If you select “AUTO”, some selections in the “AV MODE” menu may not be automatically set. Indd 24 2009/10/09 14:13:07 Basic adjustment Audio settings Audio Emphasising dialogue Option DYNAMIC Treble Bass Balance Surround Bass enhancer Reset L30 R30 [Off] Clear voice This function emphasises speech against background noise for greater clarity. Outputting audio only Option Audio Audio adjustment You can adjust the sound quality to your preference with the following settings. Selectable items Treble Bass Balance c (Cursor) For weaker treble For weaker bass Decrease audio from the right speaker d (Cursor) For stronger treble For stronger bass Decrease audio from the left speaker Audio only When listening to music from a music programme, you can set the TV off and enjoy audio only. [. . . ] The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. NOTE • Refer to the inside back cover for dimensional drawings. 2 For further information about the Energy Save function, please see related pages in this operation manual Measured according to IEC 62301 Ed. [. . . ]