User manual SHARP LL-T1803-H/B

[. . . ] 10 Connecting the monitor and turning the monitor on and off . WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT GAIN CONTROL WHITE BALANCE MODE SELECT OSD Menu disappears) Notes: - The OSD Menu automatically disappears several seconds after the last command. PHASE The figure below demonstrates how to adjust so that buttons) horizontal flicker noise is not emitted. ( Note: - Adjustments to PHASE should be made only after CLOCK has been correctly set. H-POS (horizontal positioning) and V-POS (vertical positioning) To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and buttons) the up-down (V-POS) values. - To choose a menu option:SELECT button - To go to the next menu: MENU button * Auto Gain Control function - The Auto Gain Control adjusts contrast and black level based on the brightest color of the image displayed. If you are not using the Adjustment Pattern it is necessary to have an area of 5 mm x 5 mm of white displayed, and if not adjustments may not be possible. (In such case , [OUT OF ADJUST] will appear and setting values remain unchanged. ) - If the signal coming from the computer is composite sync or sync on green, automatic adjustment cannot be performed. please perform manual adjustment instead. BLACK LEVEL Total screen brightness can be adjusted while buttons) watching the color pattern. Notes: - On settings other than [STD] not all graduations can be displayed. - Selecting USER will display the setting values for [R-CONTRAST], [G-CONTRAST] and [B-CONTRAST], in order to make fine adjustments. Button for yellow button for blue CONTRAST While watching the color pattern, adjustments can be buttons) made so that all graduations appear. Notes: - Depending on the resolution of the input signal, even if menu options can be selected, the display may not change. - To choose a menu option: SELECT button - When adjustment complete: MENU button OSD H-POSITION (OSD horizontal position) The position of the OSD display can be moved to the left and right. ( buttons) OSD V-POSITION (OSD vertical position) The position of the OSD display can be moved up buttons) and down. ( INPUT (Input mode) buttons) The input mode can be set. ( VESA: VESA mode MAC: Power Macintosh mode 400 LINES (degree of resolution) You can specify the horizontal resolution of a 400line screen when using US text, etc. ( buttons) 640: 640 X 400 dot mode 720: 720 X 400 dot mode (US text etc. ) Note: - As the resolution input for other than 400 lines is done automatically, there is no need to set it. sCALING (Level of scaling) Adjusts the image to optimum sharpness when buttons) Screen expansion is taken. [. . . ] Klicken Sie auf [General], und wählen Sie unter [Compatibility] die Option [Apply the new display setting without restarting]. This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]