User manual SHARP LL-T1811W

[. . . ] 10 Connecting the monitor and turning the monitor on and off . WARNING ­ FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] Using the ColorSync on the control panel, choose the profile to be used. Connecting the monitor and turning the monitor on and off 20) For digital signal The monitor can generally be used without adjustment. 23) Note: - All adjustments will be saved even after turning the power off. note: - While ALL RESET is displayed , the control buttons are disabled. - It is not possible to reset values when the adjustment lock is in place. Setting the lock) any attempted changes to adjusted values will be voided. While pressing the MENU button, press the power button (i. continue to press the button until the message appears on the screen. When the menu is unlocked: [ADJUSTENT LOCKED] will appear on the screen, and the lock will be set. When the menu is locked: [ADJUSTENT UNLOCKED] will appear on the screen, and the lock will be removed. Note: - When the lock is in place, all buttons other than the power button are disabled. Carry out the commands without the On Screen Display (OSD) Menu displayed. If the OSD Menu is displayed, press the MENU button (several times may be required) and begin when the OSD Menu has disappeared. Without the OSD Menu being displayed, push the or the button. Messages displayed on the screen and OSD Menu contents can be changed to the following languages. Use the SELECT button to choose a language. Note: - The language selection menu disappears approximately 30 seconds after the last command has been made. The adjustment values of the analogue signal time's ADJUSTMENT menu can be returned to their original ex-factory values. All adjustment values can be returned to their original ex-factory values in one command. Press the MENU button and the SELECT button simultaneously, and while doing this press the power button (i. Note: - When setting up this monitor for the first time or after having changed an aspect of the current system, perform an automatic screen adjustment before use. First display an image that makes the entire screen very bright. [. . . ] Aktivieren Sie [Display a list of all the drivers in a specific location, so you can select the driver you want. Klicken Sie auf [General], und wählen Sie unter [Compatibility] die Option [Apply the new display setting without restarting]. This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Cocher la case [Display a list of all the drivers in a specific location, so you can select the driver you want. [. . . ]