User manual SHARP LL-T1511A OPERATION MANUAL

[. . . ] R LCD MONITOR LCD FARBMONITOR MONITEUR LCD MONITOR LCD MONITOR LCD LL-T1511A LL-T1501A OPERATION MANUAL BEDIENUNGSANLEITUNG MODE D'EMPLOI MANUALE D'USO MANUAL DE FUNCIONAMIENTO (Figure shown is LL-T1511A. ) (Die Abbildung zeigt das Modell LL-T1511A. ) (Le modèle illustré ici est le LL-T1511A. ) (La figura illustrata è LL-T1511A. ) (La ilustración muestra el modelo LL-T1511A. ) Table of Contents / Inhaltsverzeichnis / Table des matières / Indice / Índice English . 99 2 Notice for Users in the USA . 10 Connecting the monitor and turning the monitor on and off . 12 Connecting the monitor to a computer (PC etc. ) . [. . . ] If the "Add New Hardware Wizard" has not appeared: (This explanation assumes that the floppy disk drive is "A drive") 1. Place the Monitor Settings Adjustment Disk in the computer's A drive. From [Settings], choose [Control Panel]. Click on [Settings], [Advanced] and [Monitor]. In [Options], check [Automatically detect Plug & Play monitors] and click on [Change]. Check [Specify the location of the driver [Advanced]] and click [Next]. Check [Display a list of all the drivers in a specific location, so you can select the driver you want. ] and click [Next]. When [Models] is displayed, click on [Have Disk], confirm that [Copy manufacturer's files from:] is [A:], and click [OK]. Select the monitor details, then click [Next], [Next], and [Finish]. 10. Check that the monitor details are displayed, then click [Apply]. 12. Remove the Monitor Settings Adjustment Disk from the A drive. Turn the monitor off at the main switch. Connecting a USB device If your computer or computer's OS is USB compatible, the monitor can be connected to a USB device. Plug one end of the USB cable (provided) into the monitor's USB upstream port. Connect the other end of the USB cable into the computer or the USB downstream port. Notes: · Please use a USB cable that has a length of less than 3 metres. · Before connecting, ensure that the shape of the USB cable connector is correct. · For information regarding the USB function (such as set-up) please refer to the operation manual of the computer to be connected. · Some computers, OS and other devices may not be able to be activated. To ascertain a certain device's USB compatibility, please contact the manufacturer of the device. USB specifications Standard: Based on USB standard (Rev. 1. 1), bus-powered hub Downstream port power supply: 100 mA per port maximum USB cable (provided) USB upstream port To the computer or another USB hub's downstream port 3. Plug the USB device into the monitor's USB downstream port. USB downstream port 15 English Connecting the monitor and turning the monitor on and off Adjusting the screen display If necessary, the screen can be adjusted as follows. Automatic screen adjustment (right column) The clock, phase, H-POS (horizontal positioning) and V-POS (vertical positioning) functions can be adjusted automatically. Adjustment of backlight (p. 17) Brightness of backlight can be adjusted. [. . . ] There are many varieties of DDC due to the differences between systems. This monitor works with DDC1 and DDC2B. 24 An arm or stand based on the VESA standard (purchased separately) can be attached to the monitor. To install the arm an AC adapter (purchased separately) is required. When choosing the arm to be installed take note of the following points. [. . . ]