User manual SHARP MD-MT45H

[. . . ] PORTABLER MINI-DISC RECORDER LECTEUR-ENREGISTREUR MINIDISC PORTABLE GRABADOR/REPRODUCTOR MINIDISC PORTÁTIL BÄRBAR MINISKIVINSPELARE REGISTRATORE DI MINIDISCHI PORTATILE DRAAGBARE MINIDISC RECORDER PORTABLE MINIDISC RECORDER MODELL MODELLO MODÈLE MODEL MODELO MODEL MODELL MD-MT45H BEDIENUNGSANLEITUNG MODE D'EMPLOI MANUAL DE MANEJO BRUKSANVISNING MANUALE DI ISTRUZIONI GEBRUIKSAANWIJZING OPERATION MANUAL DEUTSCH FRANÇAIS ESPAÑOL SVENSKA ITALIANO ······ Siehe Seiten i bis vi und D-1 bis D-44. ······ Se reporter aux pages i à vi et F-1 à F-44. ······ Consulte las páginas i al vi y S-1 al S-44. ······ Hänvisa till sidorna i till vi och V-1 till V-44. [. . . ] One track number will be added every time the REC button is pressed. , , To prevent recorded MiniDiscs from being erased accidentally Slide the accidental erase prevention tab, located on the side of the MiniDisc, in the direction indicated by the arrow. The MiniDisc will then be protected against accidental erasure. Useful Features You can record several pieces of music as a single track by disabling the auto marker function. When a recording is paused or whilst recording. . . To add a recording to such a MiniDisc, slide the accidental erase prevention tab back to its original position. Note: When making digital recordings using a CD player or an MiniDisc player, track numbers will be created automatically regardless of the setting of the auto marker function. , , Helpful tip when attaching a label When attaching a label to a MiniDisc cartridge, be sure to note the following. If the label is not attached properly, the MiniDisc may jam inside the unit and it may not be possible to remove it. z If the label peels off or partially lifts away, replace it with a new one. z Do not put a new label on top of an existing one. z Attach the label only in the specified location. ENGLISH E-18 00/12/27 E_45SEEG_4. fm -Advanced Recording- , , Recording tracks as a single track Advanced Recording (continued) , , About track numbers 1. Track numbers are created automatically during recording via the analogue connection when a silence of 1 second or more is detected (Auto marker function). A series of tracks can be recorded as one by disabling the auto marker function, see page 18. z When recording, if a programmed playback is performed by the source or playback is performed by selecting tracks manually, the MiniDisc track numbers may not be the same as on the source. z Track numbers may not be created properly, depending on the connected stereo system. , , About sampling rate converter This portable MD incorporates a sampling rate converter meaning it can record from digital radios or DAT tape recorders. Useful Features -Advanced Recording- , , Note for digital recording 2. When recording from a CD or a MiniDisc using the digital connection, track numbers will be created at the same points as on the CD or MiniDisc (Synchro marker function). You cannot copy a MiniDisc that you recorded from digital inputs to another MiniDisc or DAT. It is prevented by the SCMS (Serial Copy Management System). Recording from analogue inputs is not affected. z Track numbers may not be created in proper places, depending on the source to be recorded from, such as signals with noise. z The track numbers on the playback side may not match the track numbers recorded on the MiniDisc. E-19 ENGLISH 00/12/27 E_45SEEG_4. fm Recording from a Microphone , , To record from a microphone 4 Press the ing level. or button to adjust the record- Adjust the recording level so that the maximum sound volume from the source makes the reading swing between --- 4 dB and 0 dB. 5 Press the PLAY/PAUSE button. Recording will start. To interrupt a recording Press the PLAY/PAUSE button whilst recording. z To resume recording, press the PLAY/PAUSE button again. The track number will be increased by one each time you interrupt a recording. To stop recording 1 2 3 Connect a stereo microphone to the MIC IN socket. Press the REC button. Press the /:OFF button. To write recorded contents on the MiniDisc Press the /:OFF button whilst in the stop mode. ENGLISH E-20 00/12/27 E_45SEEG_4. fm -Recording from a Microphone- Useful Features Recording from a Microphone (continued) , , Sound-actuated recording (Mic Synchronised recording) About pause function The unit automatically pauses when the microphone does not pick up any sound for 3 seconds or more. [. . . ] z Is an optical signal being output from the stereo system?Read the operation manual for the stereo system. When the operation buttons are pressed, the unit does not respond. Recording and editing are impossible. E-41 ENGLISH 00/12/27 E_45SEEG_6. fm Maintenance , , If trouble occurs When this product is subjected to strong external interference (mechanical shock, excessive static electricity, abnormal supply voltage due to lightning, etc. ) or if it is operated incorrectly, it may malfunction. If such a problem occurs, do the following: 1. [. . . ]