User manual SHARP MD-MT80

[. . . ] PORTABLE MINIDISC RECORDER MODEL Thank you for purchasing this SHARP product. For the best performance, read this manual carefully. It will guide you in operating your SHARP product. MD-MT80H OPERATION MANUAL If you require any advice or assistance regarding your Sharp product, please visit our web-site www. sharp. co. uk/support. Customers without internet access may telephone 08705 274277 during office hours (or (01) 676 0648 if telephoning from Ireland). Accessories -Accessories/Optional Accessories- Important Introduction Earphones x 1 AC Adaptor (RADPA8046AWZZ) x 1 Connection Cable (for analogue recording) x 1 Notes: ! [. . . ] z When the portable MD is turned on or operating, the battery will not be charged. 28 Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) , , About charging time After about 3. 5 hours have passed, " " will go out. The battery charging is about 90% complete. To charge the battery fully, continue charging for about 2 more hours. In this case, you do not need to press the MODE/CHRG button. Even if the MODE/CHRG button is pressed, " " will not appear. Notes: z Charge the battery within the range of 5°C - 35°C (41°F - 95°F). z Charging is completed when " " does not blink when you plug in the AC adaptor and press the MODE/CHRG button. z The unit can be left in the charging state after it is completed. Caution: z Use the specified battery AD-N70BT only. Do not charge a battery (nickel-cadmium, alkaline, etc. ) other than that specified. z Do not remove the outer cover of the rechargeable battery. It may cause heat generation, fire, or explosion. z Do not dip the battery in water, do not dispose of it in a fire, and do not take it apart. z If the rechargeable battery terminal is dirty, charging may not start. In such a case, wipe off the dirt with a dry cloth. z Do not disassemble the battery. , , Using with the rechargeable or alkaline battery 1 2 Disconnect the AC adaptor. Insert the rechargeable battery or alkaline battery from the (+) marked side. Use a commercially available LR6, "AA" size alkaline battery. Useful Features Notes: z Setting the volume level to "0" whilst recording with the rechargeable or an alkaline battery reduces the battery drain. z When you do not use the unit for hours, remove the battery. (The battery drains gradually even when the power is turned off. ) z This unit can be used with the AC adaptor when the rechargeable or an alkaline battery is in the unit. Caution: Do not use a nickel-cadmium battery. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) 29 -Battery Power- Hold Function The present operation condition can be kept even if other buttons are accidentally pressed in a place such as a crowded train. Useful Features -Hold FunctionIf the battery is inserted or the AC adaptor is connected, you can set this function even when the power is turned off. To cancel the hold mode Press and hold down the HOLD button for 2 seconds or more whilst the unit is in the hold mode. "HOLD OFF" will be shown. If the hold function is active whilst the power is turned off, the power cannot be turned on by mistake and the battery will not be drained. 30 Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) Changing Default Settings Whilst in the stop mode . . . , , Beep sound , , Auto play 1 With a MiniDisc inserted, press the MODE/ CHRG button for 2 seconds or more. "SET UP" will appear. When you release the button, "BEEP ON" or "BEEP OFF" will appear. You can eliminate the confirmation sound that beeps when you press a button. [. . . ] The condensation should evaporate and the unit will work properly. Web-site: www. sharp. co. uk/support Help Line: 08705 274277 (office hours) 45 -Maintenance- Specifications As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units. , , General Power source: DC 5V: AC adaptor (AC 230-240V, 50/60 Hz) Commercially available, "AA" size (LR6), alkaline battery x 1 Optional rechargeable Nickel-Metal Hydride battery (AD-N70BT) x 1 Optional car adaptor, AD-CA20X(for cars with a 12 - 24V DC negative earth electrical system) 7 W (AC adaptor) RMS; 20 mW (10 mW + 10 mW) (0. 2% T. H. D. ) Approx. [. . . ]