User manual SHARP MX-BMX1

[. . . ] BOOKLET MAKER MX-BMX1 Operating Instruction Stapler Folder Reference Read this manual carefully before you use this product and keep it handy for future reference. For safety, please follow the instructions in this manual. 15 October 2010 Part no: ##### Doc no: x04090 rev , 15 October 2010 Warning: This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate measures. The product (System) which is connected to this machine will be class A Note The domestic environment is an environment where the use of broadcast radio and television recievers may be expected within a distance of 10 m of the apparatus concerned. Introduction This manual contains instructions on the operation and maitenance of this machine. [. . . ] Hold the stapler head in place, press the release latch (B) to release the rear end of the stapler head and lift up this end. Lift out the head, allowing it to rotate around the front end. The stapler assembly is spring loaded and will follow the rotation of the stapler. B A Removing staple cartridge The staple cartridges, containing approximately 5000 staples per cartridge. Cartridge may be removed either for renewal or for jam clearance. Raise the handle (C) on the staple cartridge locking lever. Remove the staple cartridge from the stapler head by sliding it away from the stapler head. C 26 Installing stapler head, staple cartridge / clearing staple jam Look inside stapler head for jammed staples in the area of the staple actuator. Position the stapler head on the edge of a firm surface (for example the top of a table). While securely holding the head, actuate the Stapler up and down through full travel. Perform this operation without staple cartridge Renewing or reinstalling the staple cartridge, pull 25 mm (1 inch) of staples out of the cartridge and tear the staples downward starting at one side pulling away from you. The staple tear line is indicated by an arrow on the side of the cartridge. Insert the cartridge into the stapler head with the end of the staples facing toward the head of the stapler mechanism. Hold the staple cartridge firmly in place and push down the cartridge locking lever. IMPORTANT Keep holding (pushing) the staple cartridge into place while pushing down the cartridge locking lever. While securely holding the head, actuate the Stapler up and down through full travel. Perform this operation with staple cartridge. Repeat this a few times to ensure that the staples are ejected at each down movement. Reinstall the stapler head by inserting the pin at the top of the stapler head into the stapler retraction swing arm (D). While rotating the stapler head, insert the pin located at the rear end of the stapler head into the slots in the frame of the stapler head assembly. Press down the rear end of the stapler head until the release lever snaps into place, locking the stapler head in position. Press down the front end of the stapler head until it snaps in position under the frame assembly. Reconnect the staple indication lead (A), see previous page. Close the top cover and press the [Esc] button. [. . . ] Cycle the Stapler head a couple of times before installing it again. 59 Cover Feeder Cleaning feed rollers and paper separator pad The Feed rollers need to be cleaned regularly when in use, and if the unit has not been used for a period of time. How often this should be done, depends on the paper type and print quality. An increasing number of misfeeds, or double feeds, is one indication of the need to clean the Feed Rollers. Remove the feed roller assembly by pressing it to the front of unit (A). [. . . ]