User manual SHARP MX-M363 BROCHURE

[. . . ] This manual explains settings related to general use of the machine, settings for the copy function, and settings for the document filing function. For administrator settings related to the printer function, fax function, network scanner function, and Internet fax function, see the following manuals: Printer . Operation manual (for printer), chapter 5 Fax . Operation manual (for facsimile), chapter 8 Network scanner / Internet fax . [. . . ] Disabling of inserter Use this setting when you wish to prohibit the use of the inserter or when it has failed. Disabling of covers/inserts mode Use this setting to prohibit the use of covers/inserts mode. 11 GENERAL SETTINGS Saddle stitch position adjust This setting is used to adjust the stapling position (folding position) when the saddle stitch function of the optional saddle stitch finisher is used. The value can be adjusted in 0. 25 mm increments within ±2. 00 mm from the reference position for each paper size. Max. +2mm Position adjusted to the plus direction Min. -2mm Position adjusted to the minus direction Rotated output When Rotated output is turned on, you can have the paper output orientation (A4-size paper only) of each set of copies alternate between horizontal and vertical. This function is used to sort output when neither the Finisher peripheral nor the Saddle stitch finisher peripheral are installed. * To use this function, A4-size paper must be loaded both horizontally and vertically in the paper trays. This function works when paper is output to the centre tray. 1 2 11 12 Reference position [AUTOMATIC SADDLE STITCH] checkmark The saddle stitch print function can normally be divided into the following three general steps. The pages of the original are automatically reordered to allow saddle stitch binding (saddle stitch function). The paper is stapled at the centre in two places (saddle stitch stapling). The [AUTOMATIC SADDLE STITCH] checkbox is selected by default. Selection of the checkbox assumes the use of the above saddle stitch printing function (three steps). Saddle stitch stapling exceptions Depending on the purpose of saddle stitch stapling, it may be necessary to perform saddle stitch stapling on printed matter that has already been bound by saddle stitching. IPv4 setting IPv6 setting Enable TCP/IP Enable NetWare Enable EtherTalk Enable NetBEUI Reset the NIC Tandem setting PING command NOTE For setting and modification of "Network settings", be sure to consult with the network administrator. IPv4 setting When using this product in a network that uses the TCP/IP protocol (IPv4), use this setting to set the IP address (IP address, IP subnet mask, and IP gateway) of this product. The setting is set to ENABLE DHCP by factory default setting, which obtains the IP address setting automatically. When using this product on a TCP/IP network, be sure to turn on the "Enable TCP/IP" setting below. If DHCP is used, the IP address assigned to the machine may be changed automatically on occasion. If this happens, printing will not be possible. IPv6 setting When using this product in a network that uses the TCP/IP protocol (IPv6), use this setting to set the IP address (enable IPv6, DHCPv6, IP address, prefix length, and default gateway) of this product. By factory default, the IPv6 setting is disabled. When using this product on a TCP/IP network, be sure to turn on the "Enable TCP/IP" setting below. In an IPv6 environment, the machine can use LPD or IPP protocol. If DHCP is used, the IP address assigned to the machine may be changed automatically on occasion. [. . . ] Files saved in modes that are not selected cannot be printed from the [JOB SETTINGS] screen. · Similarly, the [SCAN TO E-MAIL/FTP], [FAX SEND], and [I-FAX SEND] keys control the corresponding transmission operations in the [JOB SETTINGS] transmission screen. Administrator authority setting When a password has been established for a file, user name, or folder, this setting is used to allow the administrator password to be entered instead of the password in order to delete the item. This is only for deletion; editing is not possible. [. . . ]