User manual SHARP NA-V135HR INSTALLATION GUIDE

[. . . ] Never use the plug without the fuse cover fitted. In the unlikely event of the socket outlet in your home not being compatible with the plug supplied either cut-off the moulded plug (if this type is fitted) or remove by undoing the screws if a rewireable plug is fitted and fit an appropriate type observing the wiring code below. DANGER: The fuse should be removed from the cut-off plug and the plug destroyed immediately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur. [. . . ] When loading paper, ensure there is no space between the paper and the guide, and check if the guide is not set too narrow causing the paper to bend. Loading paper in these ways will result in document skew or a paper jam. If you use the unit in a country other than the country where the unit was purchased, you will need to make sure that your local power supply is compatible with your model. If you plug the unit into an incompatible power supply, irreparable damage to the unit will result. Ensure that the power switch of the unit is in the OFF position. Insert the attached power cord into the power cord socket at the rear of the unit. Turn the power switch on the left side of the unit to the "ON" position. Plug the other end of the power cord into the nearest outlet. Only insert the power cord into a properly grounded wall socket. Do not use extension cords or power strips. About the scan head The scan head lamp remains on constantly when the unit is in the ready condition (when the start ( ) indicator is illuminated). Supply TD cartridge Part number AL-214TD Usable life Approx. For best copying results, be sure to use only SHARP Genuine Supplies which are designed, engineered, and tested to maximize the life and performance of SHARP copiers. 18, 000 sheets * Based on copying onto A4-type paper at 5% toned area (The life of the TD cartridge which has been included in the machine at the factory is approximately 2, 000 sheets. The MSDS (Material Safety Data Sheet) can be viewed at the following URL address: http://www. Each instruction also covers the optional units used with the product. The SOFTWARE LICENSE will appear when you install the software from the CD-ROM. By using all or any portion of the software on the CDROM or in the machine, you are agreeing to be bound by the terms of the SOFTWARE LICENSE. The label ( ) in the fusing area of the machine indicates the following: : Caution, risk of danger : Caution, hot surface Products that have earned the ENERGY STAR® are designed to protect the environment through superior energy efficiency. The products that meet the ENERGY STAR® guidelines carry the logo shown above. The products without the logo may not meet the ENERGY STAR® guidelines. CAUTION: Do not install the machine in a location with poor air circulation. [. . . ] After turning the machine off, wait 10 to 15 seconds before turning it back on. Machine power must be turned off before installing any supplies. When the machine is not used for a long time, for example for consecutive holidays, turn the power switch off and remove the power cord from the outlet. When moving the machine, be sure to turn the power switch off and remove the power cord from the outlet. [. . . ]