User manual SHARP ND-198U1F DATASHEET

[. . . ] Shielded interface cables must be used with this equipment to maintain compliance with EMC regulations. The equipment should be installed near an accessible socket outlet for easy disconnection. MAINS PLUG WIRING INSTRUCTIONS The mains lead of this equipment is already fitted with a mains plug which is either a non-rewireable (moulded) or a rewireable type. Should the fuse need to be replaced, a or and of the same rating as BSI or ASTA approved fuse to BS1362 marked the one removed from the plug must be used. [. . . ] ) Locations exposed to direct sunlight Plastic parts may become deformed and dirty output may result. Do not throw a toner cartridge into a fire. Store a toner cartridge out of the reach of children. Do not install the machine in a location that will block the ventilation ports. Blocking the ventilation ports will cause heat to build up in the machine, creating a risk of fire. The fusing unit and paper exit area are hot. When removing a misfeed, do not touch the fusing unit and paper exit area. Do not place a container of water or other liquid, or a metal object that might fall inside, on the machine. When loading paper, removing a misfeed, performing maintenance, closing the front and side covers, and inserting and removing trays, take care that your fingers are not pinched. Locations with ammonia gas Installing the machine next to a diazo copy machine may cause dirty output. If the liquid spills or the object falls into the machine, fire or electrical shock may result. Wave length Pulse times Output power 790 nm ± 10 nm Normal paper mode (P/S = 104 mm/s) = (5. Near a wall Be sure to allow the required space around the machine for servicing and proper ventilation. (The machine should be no closer than the distances indicated below from walls. The indicated distances are for the case 30 cm when a saddle finisher and large capacity paper tray are not installed. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. This Digital Equipment is CLASS 1 LASER PRODUCT (IEC 60825-1 Edition 2-2007) Each instruction also covers the optional units used with these products. Noise emission values as measured according to ISO7779 are listed to the right. In particular, never move the machine while the power is on. The machine should be installed near an accessible power outlet for easy connection. Connect the machine to a power outlet which is not used for other electric appliances. Do not look directly at the light source. [. . . ] You might be charged for the costs arising from take-back and recycling. Small products (and small amounts) might be taken back by your local collection facilities. For Spain: Please contact the established collection system or your local authority for take-back of your used products. In other Countries outside the EU Please take care not to forget newly set administrator passwords. [. . . ]