User manual SHARP ND-208U1 DATASHEET

[. . . ] Do not use the unit if the power cord or plug is damaged or the connection to the wall outlet is loosened. Periodically remove dust from the power plug. Do not insert fingers or foreign objects into the intake or air outlet. When removing the power plug, always hold the plug and never pull the cord. [. . . ] Do not use mineral water, ionized alkaline water, well water, purified water, etc. If the tank cap is difficult to tighten, loosen the cap one full turn to properly set the cap to the tank. When the tank is dry and the water in the tray begins to dry up, the Water Supply Indicator Light will begin to flash. When not operating in Humidify Mode, press the Humidify Mode Selection Button to turn the mode OFF; the Water Supply Indicator Light will turn off. Mode activates after the short "beep". Unless unplug the power cord, the operation starts in the previous mode the unit was operated in. When stop operation during ION SHOWER Operation, the unit will back to the prior operation of ION SHOWER Operation. When the tank is dry, the Water Supply Indicator Light turns on. When not operating in Humidify Mode, turn the mode OFF by pressing the Humidify Mode Selection Button; the Water Supply Indicator Light will turn off. Mode stops running after the long "beep". (Direct start is available even when the unit is not turned on. Use when the Plasmacluster Indicator Light and the CLEANSIGN Light are too bright. (Please press the Plasmacluster ON/OFF Button for 3 seconds 2 short beeps are generated. When the Plasmacluster ON/OFF Button is released before the 2 short beeps, The Plasmacluster Ion Mode switches between ON and OFF; the CLEANSIGN Light does not turn ON/OFF because only the Plasmacluster Indicator Light turns ON/OFF. To maintain optimum performance of this air purifier, please clean the unit including the sensor and filters periodically. When cleaning the unit, be sure to unplug the power cord, and never handle the plug with wet hands. Care Cycle 1 month To prevent dirt or stains on the main unit, clean as often as necessary. If stains are allowed to remain, they may become hard to clean. Wipe with a dry, soft cloth For stubborn stains or dirt, use a soft cloth dampened with warm water. Keep the unit away from water With a small amount of water inside and the tank cap closed, wash the tank set by shaking it. When using a kitchen detergent, dilute the detergent with water and rinse it thoroughly. SENSORS (*DUST SENSOR, ODOUR SENSOR, TEMPERATURE/HUMIDITY SENSOR) Care Cycle 2 months * Only KC-6500E is equipped with the Dust sensor. [. . . ] (JEM1467) · Humidification Amount changes in accordance with indoor and outdoor temperature and humidity. Standby Power In order to operate the electrical circuits while the power plug is inserted in the wall outlet, this product consumes about 0. For energy conservation, unplug the power cord when the unit is not in use. Attention: If you want to dispose of this equipment, please do not use the ordinary dust bin! [. . . ]