User manual SHARP NU-220-R1H INSTALLATION CRYSTALLINE MODULES

[. . . ] Congratulations on your new solar system!You have made an excellent decision by choosing a photovoltaic system from Sharp Solar ­ you have chosen quality, innovation and reliability. The solar power station from Sharp Solar is your very own state-of-the-art power source. Sharp Solar is one of the world's technological leaders in solar power and has 50 years of experience in solar technology. [. . . ] Do not drop PV module or allow objects to fall down on the PV module. Do not grab the PV module at only one side. Grab the PV module at two sides facing each other. Always wear protective head gear, insulating gloves and safety shoes (with rubber soles). Keep the PV module packed in the carton until installation. Do not touch the PV module unnecessarily during installation. the glass surface and the frames get hot. There is a risk of burn, or you may collapse because of electric shock. Do not work under rain, snow or windy conditions. When installing PV modules far above ground, do not drop any object (e. Make sure flammable gases are not generated near the installation site. Completely cover the PV module surface with an opaque material during PV module installation and wiring. Due to the risk of electrical shock, do not perform any work if the terminals of PV module are wet. Do not touch the terminal box and the end of output cables, the cable ends (connectors), with bare hands during installation or under sunlight, regardless of whether the PV module is connected to or disconnected from the system. There is a risk of injury or electric shock if glass is broken. Do not work alone (always work as a team of 2 or more people). Wear a safety belt if working far above the ground. Do not wear metallic jewelry which can cause electric shock during installation. Do not damage the back sheet of PV modules when fastening the PV modules to a support by bolts. Do not damage the surrounding PV modules or mounting structure when replacing a PV module. Drooping down of cables from the terminal box could possibly cause various problems such as animal biting, electricity leakage in puddle. Take proper measures for preventing the laminate (consisted of resin, cells, glass, back sheet, etc. [. . . ] The array rails must support the bottom of the frames and must be continuous pieces (no breaks in the rail). Mounting Using Clips on long edge of module: long edge Perpendicular to array Rails (figure 5) The modules may also be mounted using clips on the long sides of the module when the array rails are perpendicular to the long sides, as shown in Figure 5. The clip centerlines must be between 150 mm and 410 mm from the ends of the module. note that the mounting clips should meet the minimum dimensions (catch width of 5 mm and length of 38 mm) shown in Figure 2. [. . . ]