User manual SHARP PC-A150

[. . . ] In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug and fit an appropriate type. DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur. To fit an appropriate plug to the mains lead, follow the instructions below: IMPORTANT: The wires in the mains lead are coloured in accordance with the following code: Blue: Neutral Brown: Live As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: · · The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black. [. . . ] · If the actual remaining power in your battery is less than what Windows Power Meter indicates, you should condition the battery pack as per the procedure on Conditioning the Battery Pack section. 3-2 Low Battery Indication When the battery power becomes significantly low (under 10%), the battery status indicator ( ) blinks red, the warning beep sounds. Save your data and turn off the computer, or connect the computer to AC power immediately. Otherwise, the computer will be shut down and the data may be lost. To stop the warning beep sound, press Fn + F10. Battery Status Indicator 3 In Windows XP, the alarm will tell you when the battery drops to the specified level by sounding an alarm or displaying a message, and let your computer go on System standby/hibernate or shut down automatically. In the Power Options Properties dialog box, select Alarms tab. Set the battery level at which the alarms are activated. We recommend you set Critical battery alarm to 5 % or more and Low battery alarm to more than that of Critical battery alarm. Close the Control Panel window. 3-3 Conditioning the Battery Pack You need to condition the battery pack when the actual remaining power in your battery is less than what Windows Power Meter indicates, or you buy a new battery pack. Connect the computer to AC power and wait until the battery is fully charged. The battery status indicator turns orange first; then, turns to green when the battery pack is fully charged. When the message <F2> to enter System Configuration Utility appears, press F2 to open the Setup Utility. Close the Control Panel window. 3-7 Using System Standby/Hibernate System standby/hibernate is a very useful power management tool. For example, after your computer has entered System standby mode, you can restart your computer more quickly when compared to a restart, after a normal shutdown operation. When your computer resumes from System standby/hibernate, the system restores the exact last state of the computer. In Windows XP, you can define System standby or System hibernate the system enters under what conditions. · System standby stores the current condition of the computer in RAM and stops power supply to all but a few essential components. Your system enters and resumes from System standby per the conditions mentioned later. In System standby, the Power indicator or the battery power indicator blinks green. To resume from System standby, operate the computer again. System hibernate saves the current condition of the computer in an area of the hard disk and turns off the computer. Your system enters and resumes from System hibernate per the conditions mentioned later. In System hibernate, the power indicator or the battery power indicator turns off. To resume from System hibernate, press the power button. [. . . ] The information about IP appears. T-7 Troubleshooting Question: Why can't I access the LAN? 3. See the numbers of Physical Address in Ethernet adapter Local Area Connection section (for LAN) or Ethernet adapter Wireless Network Connection section (for Wireless LAN /for a built-in wireless LAN model only). Type exit; then, press Enter. 4. Trouble with Peripherals Question: Why don't peripheral devices function? · · · · · · · · · Troubleshooting Confirm they are correctly connected to your computer. Confirm drivers necessary for the devices are installed. Question: Why can't I print? Make sure the printer is turned on. Check whether the computer and the printer are connected correctly. [. . . ]