User manual SHARP PC-A250

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · · · · Reorient or relocate the receiving antenna. Increase the distance between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] Otherwise, you cannot set or change some settings for wireless LAN. Click Network and Internet Connections ­ Network Connections. If Classic view is selected, click Network Connections. Select Wireless Network Connection; then, click Change settings of this connection of Network Tasks. Double-click Internet Protocol (TCP/IP) in This connection uses the following items. In Internet Protocol (TCP/IP) Properties dialog box, select Use the following IP address and set a unique IP address to 192. 168. 1. 2 through 192. 168. 1. 254 and the Subnet mask to 255. 255. 255. 0; then, click OK. · The IP address of each computer should be unique. · The Default gateway can be blank. 6. 9. Click Wireless Networks tab; then, click Advanced button in the lower right of the dialog box. Select Computer-to-computer (ad hoc) networks only; then, click Close. button in Preferred networks of Wireless Network Connection Properties dialog box. Right-click Wireless Network Connection; then, click Enable. When you have more than one access points, your computer may be connected to other than right one you want to access. ) icon on the taskbar; then, click View Available Wireless · 1. 2. Select the desired network in the Available networks list; then, click Connect button. Question: Why can't I connect to the network via an access point? · · · Confirm Any available network (access point preferred) is selected in Networks to access of Advanced dialog box. (To open Advanced dialog box, refer to Communicating with Other Computers section on page 8. ) Confirm the ESSID of your computer matches the ESSID of the access point you want to communicate with. The Software is only authorized for distribution together with a specific computer. This License authorizes you to use the Software for disaster recovery purposes only, to restore the hard disk image contained on the CD to the computer with which the CD and Software were originally shipped. Without the express permission of PowerQuest, you may not (a) use, copy, modify, alter, or transfer, electronically or otherwise, the Software or documentation except as expressly permitted in this License Agreement, or (b) translate, reverse program, disassemble, decompile, or otherwise reverse engineer the Software. PowerQuest is NOT responsible to provide technical support. Any and all technical support questions, regarding the Software, should be referred to the place of purchase. If you are acquiring the Software on behalf of any unit or agency of the United States Government, the following provision applies: It is acknowledged that the Software and the documentation were developed at private expense and that no part is in the public domain and that the Software and documentation are provided with RESTRICTED RIGHTS. [. . . ] You can select the way to recover your system. · Recovers C: drive only. (Recommended) This process will format C: drive only and recover C: drive to the same status as shipped from the factory. The volume of the drives will not be changed and current ones will be kept. This process will format both C: and D: drives, and contents of the hard disk are restored to its original state in C: drive. [. . . ]