User manual SHARP PC-A500

[. . . ] The Software is a proprietary product of PowerQuest Corporation ("PowerQuest") or its licensors and is protected under U. S. copyright laws and international treaty provisions. Ownership of the Software and all copies, modifications, and merged portions thereof shall at all times remain with PowerQuest or its licensors. The Software is being licensed to you, which means you have the right to use the Software only in accordance with this License Agreement. [. . . ] The Software is only authorized for distribution together with a specific computer. This License authorizes you to use the Software for disaster recovery purposes only, to restore the hard disk image contained on the CD to the computer with which the CD and Software were originally shipped. Without the express permission of PowerQuest, you may not (a) use, copy, modify, alter, or transfer, electronically or otherwise, the Software or documentation except as expressly permitted in this License Agreement, or (b) translate, reverse program, disassemble, decompile, or otherwise reverse engineer the Software. PowerQuest is NOT responsible to provide technical support. Any and all technical support questions, regarding the Software, should be referred to the place of purchase. If you are acquiring the Software on behalf of any unit or agency of the United States Government, the following provision applies: It is acknowledged that the Software and the documentation were developed at private expense and that no part is in the public domain and that the Software and documentation are provided with RESTRICTED RIGHTS. Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in 3 Technical Data and Computer Software clause at DFARS 252. 227-7013or subparagraphs (c)(1) and (2) of the Commercial Computer Software-Restricted Rights at 48 CFR 52. 227-19, as applicable. Contractor/manufacturer is PowerQuest Corporation/P. O. The Software is being provided to you AS IS. PowerQuest does not warrant the Software to end users. If the Software fails to perform substantially in accordance with the documentation provided to your hardware supplier, PowerQuest will repair or replace the copy of the Software provided to your hardware supplier and will authorize your hardware supplier to provide such repaired or replaced Software to you without charge. You can select the volume of C: and D: drives. The contents of the hard disk are restored to its original state in C: drive. · · 5 Formatting the drives and re-installing Windows XP 1. If any peripheral devices are connected to your computer, disconnect them. If the weight saver is installed in your computer remove it and install the optical drive 4. Connect the AC adapter; then, turn on the computer. If the battery is completely discharged, the installation process will be canceled. When the message Press <F2> to enter SETUP appears, press F2. Insert the Product Recovery CD-ROM disk 1 into the optical drive. In the Exit menu, select Load Setup Defaults; then, press Enter twice. In Boot Sequence of the Boot menu, set CD-ROM Drive to the top of the list; then, press Esc. In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter twice. [. . . ] In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter twice. Read the message on the screen, and select the way to recover your system; then, press Enter. If you selected Formats hard disk and creates new partition, go to the next step. Select the volume of C: drive and press Enter. [. . . ]