User manual SHARP PC-A520

[. . . ] Use of the software indicates your acceptance of these terms. As used in this License Agreement, the term "Software" means the EasyRestore software included on the CD provided with this License Agreement. The Software is a proprietary product of PowerQuest Corporation ("PowerQuest") or its licensors and is protected under U. S. copyright laws and international treaty provisions. [. . . ] The Software is being licensed to you, which means you have the right to use the Software only in accordance with this License Agreement. The Software contains pre-installed software for disaster recovery purposes. The Software is only authorized for distribution together with a specific computer. This License authorizes you to use the Software for disaster recovery purposes only, to restore the hard disk image contained on the CD to the computer with which the CD and Software were originally shipped. Without the express permission of PowerQuest, you may not (a) use, copy, modify, alter, or transfer, electronically or otherwise, the Software or documentation except as expressly permitted in this License Agreement, or (b) translate, reverse program, disassemble, decompile, or otherwise reverse engineer the Software. PowerQuest is NOT responsible to provide technical support. Any and all technical support questions, regarding the Software, should be referred to the place of purchase. If you are acquiring the Software on behalf of any unit or agency of the United States Government, the following provision applies: It is acknowledged that the Software and the documentation were developed at private expense and that no part is in the public domain and that the Software and documentation are provided with RESTRICTED RIGHTS. Use, duplication, or disclosure by the Government is subject to restrictions as set forth in subparagraph (c)(1)(ii) of the Rights in 3 Technical Data and Computer Software clause at DFARS 252. 227-7013or subparagraphs (c)(1) and (2) of the Commercial Computer Software-Restricted Rights at 48 CFR 52. 227-19, as applicable. Contractor/manufacturer is PowerQuest Corporation/P. O. The Software is being provided to you AS IS. Formats hard disk and creates new partition. This process will format the whole hard disk drive and creates a new partition. You can select the volume of C: and D: drives. The contents of the hard disk are restored to its original state in C: drive. · · 5 Formatting the drives and re-installing Windows XP 1. If any peripheral devices are connected to your computer, disconnect them. Connect the AC adapter; then, turn on the computer. If the battery power becomes significantly low, the installation process will be canceled. When the message <F2> to enter System Configuration Utility appears, press F2. Insert the Product Recovery CD-ROM disk 1 into the optical drive. In the Exit menu, select Load Setup Defaults; then, press Enter twice. In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter twice. [. . . ] In the Exit menu, confirm Exit Saving Changes is highlighted and press Enter twice. Although the pointer may be shown on the screen, never touch the keyboard or the glide pad during recovery except when the message prompts you to. If you touch them, the re-installation will be canceled. Read the message on the screen, and select the way to recover your system; then, press Enter. [. . . ]