User manual SHARP PC-AX10

[. . . ] However, there is no guarantee that interference will not occur in a particular installation. If these equipments do cause harmful interference to radio or television reception, which can be determined by turning the equipments off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the distance between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] If you cannot find the icon, click to show all kinds of icons. If the icon does not appear, go to Step3. Click Safely remove xxxx (xxxxx is the name of your USB device); then, Safe To Remove Hardware dialog appears. Remove the device from your computer. 4-10 PC Card Your computer is equipped with a PC card (supporting PC Card Standard, CardBus compliant) slot, which can accommodate a Type II card. You can insert/eject the card without turning off your computer. Before inserting a PC card into the slot, refer to its manual. Inserting PC Card · When a new card is correctly inserted, the appropriate driver is automatically installed. If the driver is not installed correctly, you will see the message on the screen. In this case, install the PC card driver by following the instructions on the screen. · When you insert a protruding card such as wireless networking card:, · Do not give force to the card; otherwise your computer may be damaged. · Do not carry your computer with the card inserted; otherwise your computer may be damaged. Confirm the PC card eject button is inside your computer cabinet. If you connect the modem to a digital PBX, both the modem and the PBX may be damaged. · Within the communications software you are using, set the COM port of the built-in modem to COM 3 and modem name to SmartLink 56K Modem if required. · Before commencing with fax communication, it is recommended that you exit other application programs. 5-1 5 Connecting Modem to Telephone Line 1. Open the cover of the modem jack on the left side of your computer. Modem Cover To avoid damaging the modem, close the modem cover after you finish using the built-in modem. Connect the core end of the included modem cable to the modem jack and the other end to the telephone line. 5 To Telephone Line Modem Jack Be sure not to insert the modem cable into the LAN jack. It may damage the LAN jack and the modem cable. Connect the modem to the telephone line directly. Do not use a distributor or allotter. 5-2 Configuring Modem You may have already configured your modem during Windows setup process. Otherwise, make the necessary adjustments as shown below. Modem Configuration When you use the modem first time, you must type your location's information. [. . . ] When using a USB hub, connect an AC adapter to the hub. Question: Why is my MC series recognized as a removable disk or why cannot I access it through my host computer? · When you have set a password in the Setup Utility, you cannot access it. Cancel the password temporarily using the Password Utility. (See Chapter 7. ) When you remove the password in the Setup Utility instead of canceling by the Password Utility and delete the password in the Setup Utility, the MC series may be recognized as a removable disk at the next connection. In this case, follow these instructions. [. . . ]