User manual SHARP PC-FS2518 SUPPLEMENT

[. . . ] If service should be required, use only a SHARP servicing dealer, a SHARP approved service facility or SHARP repair service. Cleaning the printing mechanism If the print becomes dull after long time usage, clean the printing wheel according to the following procedures: 1) Remove the printer cover and the ink roller. 2) Install the paper roll and feed it until it comes out of the front of the printing mechanism. 3) Put a small brush (like a tooth brush) lightly to . [. . . ] When the AC adaptor is connected to the calculator, the power source is automatically switched over from dry batteries to AC power source. Make sure that you turn the calculator's power off when connecting or disconnecting the AC adaptor. CAUTION Use of other than the AC adaptor EA-63A/28A may apply improper voltage to your SHARP calculator and will cause damage. Calculation by the use of If the decimal selector is set to "F" then the answer is always rounded down ( ). PAPER FEED KEY NON-ADD / SUBTOTAL KEY CLEAR/CLEAR ENTRY KEY TOTAL KEY EQUAL KEY CHANGE SIGN KEY: Changes the algebraic sign of a number (i. RECALL AND CLEAR MEMORY KEY RECALL MEMORY KEY STORE KEY: This key is used to store the tax rate. A maximum of 4 digits can be stored (decimal point is not counted as a digit). If you enter a new rate, the previous rate will be cleared. To Install or Replace Batteries -- When the batteries become weak, the display will work but not the printer. This indicates that you should replace the batteries. Always put back the 4 batteries at the same time. Note: During tax rate calculations, a symbol " " may appear on the display; it is not printed in the operation manual. SHARP ELECTRONICS CORPORATION warrants to the first consumer purchaser that this Sharp brand product (the "Product"), when shipped in its original container, will be free from defective workmanship and materials, and agrees that it will, at its option, either repair the defect or replace the defective Product or part thereof with a new or remanufactured equivalent at no charge to the purchaser for parts or labor for the period(s) set forth below. This warranty does not apply to any appearance items of the Product nor to the additional excluded item(s) set forth below nor to any Product the exterior of which has been damaged or defaced, which has been subjected to improper voltage or other misuse, abnormal service or handling, or which has been altered or modified in design or construction. In order to enforce the rights under this limited warranty, the purchaser should follow the steps set forth below and provide proof of purchase to the servicer. The limited warranty described herein is in addition to whatever implied warranties may be granted to purchasers by law. aLL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE PERIOD(S) FROM THE DATE OF PURCHASE SET FORTH BELOW. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Neither the sales personnel of the seller nor any other person is authorized to make any warranties other than those described herein, or to extend the duration of any warranties beyond the time period described herein on behalf of Sharp. The warranties described herein shall be the sole and exclusive warranties granted by Sharp and shall be the sole and exclusive remedy available to the purchaser. Correction of defects, in the manner and for the period of time described herein, shall constitute complete fulfillment of all liabilities and responsibilities of Sharp to the purchaser with respect to the Product, and shall constitute full satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. In no event shall Sharp be liable, or in any way responsible, for any damages or defects in the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer. [. . . ] This warranty shall not apply to: (a) Any defects caused or repairs required as a result of abusive operation, negligence, accident, improper installation or inappropriate use as outlined in the owner's manual. (b) Any Sharp product tampered with, modified, adjusted or repaired by any party other than Sharp, Sharp's Authorized Service Centres or Sharp's Authorized Servicing Dealers. (c) Damage caused or repairs required as a result of the use with items not specified or approved by Sharp, including but not limited to software, paper and batteries. (d) Any replacement of accessories, glassware, consumable or peripheral items required through normal use of the product including but not limited to batteries, AC adapters, ribbons, correction tapes, ink rollers, cables, printwheel, or paper. [. . . ]