User manual SHARP PCUM10 OPERATION MANUAL

[. . . ] Notice for Users in the USA FCC Statement WARNING - FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. [. . . ] · Confirm the peripheral device you will connect is Windows 2000 compatible. · Some devices have to be turned on after the computer is turned on. · Some devices require that you install drivers before use (You may need to connect an optional external floppy disk drive unit or an optional external CD-ROM unit to install the drivers. ) 4-1 Peripheral Connection Overview USB Device* Microphone PC Card Port Bar/Display 4 Audio Equipment *Including the optional external floppy disk drive unit (CE-FD04) and the optional external CD-ROM drive unit (CE-CD05). 4-2 Using Optional External Floppy Disk Drive Unit You can use double-density (2DD) 720KB or high-density (2HD) 1. 44MB floppy disks with the optional external floppy disk drive unit (CE-FD04). Connecting Optional External Floppy Disk Drive Unit · Do not place the floppy disk drive unit on its side or upside down. · Do not press on the floppy disk drive unit. It may damage the drive or cause malfunction. · Do not place the AC adapter on the floppy disk drive unit. Connect the floppy disk drive unit cable into the unit. 4 2. Connect the core side connector of the floppy disk drive unit cable to the USB port on the computer. Be sure to let the USB mark side up when connecting the cable to the computer. USB Mark Core Handling Floppy Disks · · Do not open the shutter and touch the disk inside; otherwise, you will not be able to read or write data to the disk. Do not place floppy disks near magnets or heat source, in direct sunlight or in a dusty place, etc. 4-3 · · Never subject a disk to sudden shocks or extreme vibration. Do not drop, bend, or place heavy objects on a disk. Do not spill liquid onto a disk. Inserting and Removing a Floppy Disk Indicator Label Facing Up 4 Inserting Hold the floppy disk with the arrow facing up and towards the drive. Slide the disk into the drive until it locks into place. · Always insert a floppy disk straight into the floppy disk drive. · When inserting the disk, make sure it is not upside down. · Do not use excessive force when inserting the floppy disk. If you have difficulty inserting or removing disks, seek the assistance of an authorized service technician. · Do not touch the disk while reading/writing data. It may cause malfunction of the computer and the drive. 4-4 Removing Before removing the floppy disk, make sure the indicator of the floppy disk drive unit is not lit. Remove it and store it properly. Formatting a Floppy Disk 1. Make sure the floppy disk is not write-protected, and insert it into the floppy disk drive. Double-click My Computer on the desktop. [. . . ] The volume of the drives will not be changed and keep current ones. · Recovers both C: and D: drive This process will format both C: and D: drive, and contents of the hard disk is restored to its original state in C: drive. The volume of the drives will be back to the same as shipped from the factory. Formats hard disk and creates new partition This process will format whole hard disk drive and creates new partition. You can select the volume of C: and D: drive. [. . . ]