User manual SHARP PG-C20XE

[. . . ] Important Information Setup & Connections Operation Useful Features Maintenance & Troubleshooting Appendix OPERATION MANUAL PG-C20XE MODEL LCD PROJECTOR This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Dieses Gerät entspricht den Anforderungen der EG-Richtlinien 89/336/ EWG und 73/23/EWG mit Änderung 93/68/EWG. Ce matériel répond aux exigences contenues dans les directives 89/ 336/CEE et 73/23/CEE modifiées par la directive 93/68/CEE. Dit apparaat voldoet aan de eisen van de richtlijnen 89/336/EEG en 73/ 23/EEG, gewijzigd door 93/68/EEG. [. . . ] mark to the desired Remote control 2 TEMP. KEYSTONE INPUT AUTO SYNC 2, 3, 4 2, 3 MENU 3 4 5 BACK ENTER 1, 5 To exit from the GUI, press MENU. Operation (GUI) On-screen Display · To reset the keystone setting, press BACK. · Straight lines and the edges of the displayed image may appear jagged, when adjusting the keystone setting. Projector ON/OFF POWER LAMP Remote control Using the KEYSTONE buttons 1 Press KEYSTONE to adjust the setting. TEMP. KEYSTONE INPUT AUTO SYNC 1 MENU BACK ENTER 20 Operating the Wireless Mouse from the Remote Control You can use the remote control as a remote mouse. Connecting the Remote Mouse Receiver Connecting to the USB port on a PC or Macintosh 1 Connect one end of the supplied USB mouse control cable to the corresponding terminal on the computer. 2 Connect the other end to the USB port on the remote mouse receiver. USB mouse control cable Remote mouse receiver Operation USB port Use the USB port (PC or Macintosh) to connect the supplied USB mouse control cable to the remote mouse receiver. Connecting to the PS/2 port on a PC 1 2 3 4 Turn off the power of the PC. Connect one end of the supplied PS/2 mouse control cable to the corresponding terminal on the PC. Connect the other end to the PS/2 port on the remote mouse receiver. Turn on the power of the PC. PS/2 mouse control cable Remote mouse receiver PS/2 port Use the PS/2 port (PC) to connect the supplied PS/2 mouse control cable to the remote mouse receiver. · · · · CAUTION Do not connect or disconnect the mouse control cables to or from the computer while it is on. Do not connect both the PS/2 and USB mouse control cables to the remote mouse receiver. Windows 95 does not support USB mouse driver software. The minimum system requirements for the USB type mouse system are shown below. Windows Hardware: PC/AT compatible machine with USB port that has Windows 98/Windows 2000 or higher installed. OS: Windows 98/Windows 2000 or higher Macintosh Hardware: Macintosh series with USB port OS: Mac OS 8. 5 or higher · The wireless mouse functions can be used to operate computers compatible with PS/2 or USB type mouse systems. 21 Operating the Wireless Mouse from the Remote Control Remote Control/Mouse Receiver Positioning · The remote control can be used to control the projector within the ranges shown below. · The remote mouse receiver can be used with the remote control to control the mouse functions of a connected computer within the ranges shown below. · The signal from the remote control can be reflected off a screen for easy operation. However, the effective distance of the signal may differ due to the screen material. Controlling the Projector Remote control 7m 30° Using the Wireless Mouse Remote control 30° 30° 45° 30° 120° 4m 45° Remote mouse receiver Operation 30° Remote control Effective buttons in MOUSE mode Remote control (Front view) Using as a Wireless Mouse · When MOUSE is pressed, the buttons on the remote control light up and the remote control enters MOUSE mode. · During MOUSE mode, the cursor can be used as the pointer. MOUSE mode is for about ten seconds while the buttons are lighting. · When MENU or ENLARGE is pressed, MOUSE mode is released to the normal mode. · Be sure the supplied remote mouse receiver is connected to your computer. Mouse MOUSE RIGHT-CLICK AV MUTE · The wireless mouse may not operate correctly if your computer serial port is not correctly set up. Refer to the computer's operation manual for details of setting up/ installing the mouse driver. · For one-button mouse systems, use either the LEFT-CLICK or RIGHT-CLICK button. Remote control (Rear view) LEFT-CLICK 22 Using the GUI (Graphical User Interface) Menu Screens This projector has three sets of menu screens (INPUT 1 (RGB), INPUT 1 (COMPONENT) and INPUT 2 (S-VIDEO) or 3 (VIDEO)) that allow you to adjust the image and various projector settings. These menu screens can be operated from the projector or the remote control with the following buttons. [. . . ] ENTER button . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Extra air filter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Eyelet for lens cap strap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31 23 37 43 T TEMPERATURE WARNING indicator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]