User manual SHARP PN-K321H OPERATION MANUAL

[. . . ] PN-K321H LCD MONITOR OPERATION MANUAL Attention: Your product is marked with this symbol. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. A. Information on Disposal for Users (private households) 1. [. . . ] • If the monitor is in the input signal standby mode and you press the power button ( ), the monitor enters standby mode. 15 E Basic Operation 1 2 3 4 5 6 7 6. [MENU/ENTER] button Displays and turns off the menu screen. (See page 18. ) Settings can be entered when the menu screen is displayed. [RETURN] button In a menu screen, returns the cursor to the previous screen. TIPS • If you are using the vertical sticker (Operation buttons), substitute the following for the button displays. - Brightness adjustment button ( / ) → Brightness adjustment button ( / ) - [VOL+/ ]/[VOL-/ ] button ]/[VOL-/ ] button → [VOL+/ • If you are using the horizontal sticker (Operation buttons), substitute the following for the button displays. - Brightness adjustment button ( / ) → Brightness adjustment button ( / ) - [VOL+/ ]/[VOL-/ ] button ] button → [ / VOL+]/[VOL-/ 1. Power button ( ) Press this button to turn the power ON/OFF. Brightness adjustment button ( The brightness menu appears. BRIGHT 15 / ) Adjust the brightness with the brightness adjustment button ( / ). *  you do not press any buttons for about 4 seconds, the If BRIGHT menu automatically disappears. Move the cursor left or right in the menu screen, and increase or decrease the setting. *  The cursor moves right when the brightness adjustment button ( ) is pressed, and left when the brightness adjustment button ( ) is pressed. [VOL+/ The volume menu appears. VOLUME 15 Adjust the volume with the [VOL+/ ]/[VOL-/ ] buttons. *  you do not press any buttons for about 4 seconds, the If VOLUME menu automatically disappears. Move the cursor up or down in the menu screen, and increase or decrease the setting. *  The cursor moves up when the [VOL+/ ] button is pressed, and down when the [VOL-/ ] button is pressed. E 16 Basic Operation nSwitching the screen size WIDE Even when the screen size is changed, the display may remain the same depending on the input signal. Displays image so it fills the entire screen. NORMAL Displays image so it fills the screen without changing the aspect ratio of the input signals. Dot by Dot Displays the dots of the signals input from the connected PC as the corresponding dots on the screen. TIPS • Using this monitor’s screen-size switching to compress or expand the screen for commercial or public viewing in establishments like cafes or hotels may infringe on the rights of the creators, as protected by Copyright Law, so please be careful. • The appearance of the original video may change if you select a screen size with a different aspect ratio than the original image (e. g. TV broadcast or video input from external equipment). • When a non-wide image (4:3) is viewed with the whole screen using the screen-size switching function of this monitor, the edge of the image may be lost or appear distorted. If you wish to respect the creator’s intentions, set the screen size to “NORMAL”. • When playing commercial software, parts of the image (like subtitles) may be cropped. In this case select the optimal screen size using the screen-size switching function of this monitor. [. . . ] Information about resolution and other parameters is exchanged between the two. This function can be used if the computer supports DDC and it has been configured to detect plug-and-play monitors. There are several types of DDC, depending on the communication method used. This monitor supports DDC2B. E 30 Specifications nDisplayPort input terminal pins (DisplayPort 20 pin) No. [. . . ]