User manual SHARP PN-K322B

[. . . ] S1 IMPORTANT: To aid reporting in case of loss or theft, please record the product’s model and serial numbers in the space provided. The numbers are located in the rear of the product. Read the manuals in the “Manual” folder of the provided CD-ROM. The lightning flash with arrowhead symbol, within a triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] - Don’t place the monitor on furniture that can easily be used as steps, such as a chest of drawers. -  emember that children can become excited while watching a program, especially on a “larger than life” monitor. Care R should be taken to place or install the monitor where it cannot be pushed, pulled over, or knocked down. -  are should be taken to route all cords and cables connected to the monitor so that they cannot be pulled or grabbed by C curious children. SAFETY INSTRUCTION -  o not use the monitor where there is a lot of dust, where D humidity is high, or where the monitor may come into contact with oil or steam, as this could lead to fire. -  nsure that the monitor does not come into contact with E water or other fluids. Ensure that no objects such as paper clips or pins enter the monitor as this could lead to fire or electric shock. -  o not place the monitor on top of unstable objects or in D unsafe places. Do not allow the monitor to receive strong shocks or to strongly vibrate. Causing the monitor to fall or topple over may damage it. - Do not use the monitor near heating equipment or in places  where there is likelihood of high temperature. Do not use in an environment where there are corrosive gases (sulfur dioxide, hydrogen sulfide, nitrogen dioxide, chlorine, ammonia, ozone, etc. As this may lead to generation of excessive heat and outbreak of fire. -  o not use the monitor in places where it may be exposed to D direct sunlight. -  he AC outlet shall be installed near the equipment and shall T be easily accessible. -  o not display the same image for an extended time. The Power Cord and AC adapter -  se only the power cord and AC adapter supplied with the U monitor. -  hen handling the AC adapter, observe the following: W Incorrect handling may result in fire, electric shock, or injury. € Do not drop the AC adapter or subject it to impact. It contains high voltage N parts that are dangerous to touch. €  he AC adapter is for indoor use only. T • Do not use the supplied AC adapter with other devices. [. . . ] To turn off the power, press and hold down the power button ( for about 2 seconds. Power button ( ) ) ENGLISH Turning on the main power Power LED Main power switch Off Orange lit Caution Caution Power lamp status Green lit Status of the monitor Power on Power off (Standby mode) Input signal waiting mode • The main power must be turned on/off with the main power switch. Do not connect/disconnect the power cord or turn the breaker on/off while the main power switch is on. € When switching the main power switch off and back on, always wait for at least 5 seconds. [. . . ]