User manual SHARP PN-L802B

[. . . ] This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] * If you do not press any buttons for about 4 seconds, the VOLUME menu automatically disappears. BRIGHT +/- (Backlight adjustment) Pressing or displays the BRIGHT menu when the menu screen is not displayed. * If you do not press any buttons for about 4 seconds, the BRIGHT menu automatically disappears. SIZE (Screen size selection) Each time you press this button, the screen size changes in the following order (see pages 21 and 22): · MODE (Screen mode selection) Each time you press this button, the screen mode changes in the following order: · Color conversion is made in taking account of liquid crytal's characteristics and represents color tone close to its original image. The display disappears when this button is pressed again or disappears automatically after approximately 15 seconds. Even when the screen size is changed, the display may remain the same depending on the input signal. An image with a 4:3 aspect ratio is enlarged to fill the entire screen without changing the aspect ratio. Use this size if ZOOM 1 cuts off the subtitles. Even when the screen size is changed, the display may remain the same depending on the input signal. An image with a 4:3 aspect ratio is stretched to fill the entire screen. An image with a 4:3 aspect ratio is enlarged to fill the entire screen without changing the aspect ratio. When using the adjustment pattern (see page 31), make adjustments so that no vertical stripe noise appears in it. Adjustments to PHASE should be made only after CLOCK has been correctly set. Selecting + changes the color towards green, and selecting - changes it towards magenta. [OFF TIMER] Set the time until the monitor turns off (enters standby mode) between 0 and 23 in units of one hour. This function is disabled when 0 is specified. When the time specified in MOTION TIME 1 elapses, the screen image is moved vertically and horizontally for a certain period of time at the interval specified in MOTION TIME 2. After the movement stops and the time specified in MOTION TIME 1 elapses again, SCREEN MOTION activates again. While the screen image is moving, the edges of the screen may be hidden. [POWER ON DELAY] You can delay the screen display after the monitor is turned on. The period can be set up to 60 seconds in units of one second. When this function is activated, the power LED flashes in orange. [. . . ] (The Power LED continues flashing red and green alternately. ) Solution: · If the monitor enters standby mode due to a rise in temperature, to return to normal display, turn the main power switch off and then back on again. The monitor, however, will enter standby mode again if the cause of the temperature rise is not eliminated. Check whether the monitor is placed at a location where a quick rise in temperature is likely. [. . . ]