User manual SHARP PN-ZH10

[. . . ] Main specifications Model Dimensions Weight PN-ZH10 See the figure below. 98 kg (216 lbs. ) (Weight includes mounting fixtures and screws) As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. [. . . ] Do not modify the LCD Monitor or the accessories. Otherwise, the monitor may fall or topple over, resulting in injury. Caution: Not following these instructions could result in injury or property damage. · Tighten all the screws and bolts fully and securely. Insufficient tightening may cause the monitor to fall or topple over, resulting in injury. · Do not apply strong shock or vibration. Otherwise, the LCD Monitor may fall and break, resulting in injury. Printed in Japan EN(1) -4- -1- Supplied accessories Confirm that the following accessories have been provided with the product. 3 Attach the eye bolt connection plate (upper) to the top of the LCD Monitor. 1) Remove the eye bolt. 6 Mount the protection panel to the LCD Monitor. · Make sure all four corners are lined up. Protection panel x 1 Spacer x 2 Eye bolt connection plate (upper) x 2 Eye bolt connection plate (lower) x 2 M5 screw (long) x 4 M5 screw (short) x 4 M16 bolt x 2 Operation manual (this manual) Precautions on use · The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel. Installation requires special knowledge and qualifications. · Customers should not attempt to install, remove, or transport the LCD Monitor by themselves. · SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling. [. . . ] · Insert each spacer in the groove where the screw was removed from, and fix the spacer in place with the screw removed in step 1. 5 Remove the transport protection frame. 3) Attach the eye bolt connection plate (lower) and secure in place with the 2 supplied M16 bolts. · Secure the eye bolt connection plate by sliding the tabs into the slots in the protection panel. Spacer Eye bolt connection plate (lower) 8 -2-3- Confirm that the LCD Monitor is mounted securely, and then remove the hooks of the hoisting device. [. . . ]