User manual SHARP PN-ZK10

[. . . ] Main specifications Model Dimensions Weight PN-ZK10 See the figure below. 23 kg (50. 7 lbs. ) (Weight includes two mounting brackets and bolts) As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. [. . . ] Do not modify the LCD Monitor or the accessories. Otherwise, the monitor may fall or topple over, resulting in injury. · Install the LCD Monitor in a location with minimal vibration and that is strong enough to hold the weight of the LCD Monitor and mounting brackets. Otherwise, the monitor may fall or topple over, resulting in injury. · Do not apply a load other than the LCD Monitor to the mounting brackets. Otherwise, the monitor may fall or topple over, resulting in injury. Caution: Not following these instructions could result in injury or property damage. · Tighten all the screws and bolts fully and securely. Insufficient tightening may cause the monitor to fall or topple over, resulting in injury. · When any deformation or cracks are found please stop using the LCD Monitor. Using the monitor without repairing the problem may cause the monitor to fall or topple over, resulting in injury. Printed in Japan EN(1) -4- -1- Supplied accessories Confirm that the following accessories have been provided with the product. 4 Attach the mounting brackets on the rear of the LCD Monitor. 1) Attach 4 supplied M16 bolts, 2 on the right and 2 on the left as shown below, and slightly tighten the bolts. 6 Attach the LCD Monitor (mounting brackets) to the H-shaped steel frame. 1) Hook the bottoms of the mounting brackets to the bolts attached in step 5. Mounting bracket x 2 M8 bolt x 4 M10 bolt x 4 M16 bolt x 8 Countersunk bolt (M10) x 2 M8 spring washer x 4 M8 plain washer x 4 M16 spring washer x 4 M16 plain washer x 4 M10 (countersunk bolt) plain washer x 2 Operation manual (this manual) Precautions on use 2) · The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel. Installation requires special knowledge and qualifications. · Customers should not attempt to install, remove, or transport the LCD Monitor by themselves. · SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling. · The installation requires two H-shaped steel frames set upright with bored mounting screw holes. For details, contact your product dealer. [. . . ] If it is difficult to loosen the bolts, lift the monitor up slightly with the hoisting device to reduce the load on the bolts. · Check the hoisting condition frequently to prevent the LCD Monitor from falling. 4) Insert the 4 supplied M8 bolts from the sides of the mounting brackets (2 for each) and secure them. M8 plain washer 4) Fully tighten the bolts which were tightened halfway in step 1). 5 Attach the supplied M10 bolts to the H-shaped steel frame so that you can hook the LCD Monitor (mounting brackets). 1) Attach the bolts onto the both sides of the right and left frames and ensure that all 4 of the bolts are aligned at the same height. M8 spring washer 7 Confirm that the LCD Monitor is mounted securely, and then remove the hooks of the hoisting device. -2- -3- [. . . ]