User manual SHARP PN-ZS1C

[. . . ] Installation procedure (continued) Main specifications Model Dimensions Weight PN-ZS1C See the figure below. 77 kg (169. 8 lbs. ) (Weight includes support rods, covers and screws) 5 Attach the left and right back cover with 16 supplied M6 screws. Cables can be bundled by attaching the cable clamp to the back cover. Operation Manual Stand cover Applicable models (as of July 2008) LCD MONITOR LB-1085 PN-ZS1C Back cover As a part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. [. . . ] · Secure the stand with the anchor bolts before assembling these parts. Otherwise, the monitor may topple over, resulting in injury. · Only use the accessories with specified models. Do not modify the LCD Monitor or the accessories. Otherwise, the monitor may fall or topple over, resulting in injury. Caution: Not following these instructions could result in injury or property damage. · Tighten all the screws and bolts fully and securely. Insufficient tightening may cause the monitor to fall or topple over, resulting in injury. · When any deformation or cracks are found please stop using the LCD Monitor. Using the monitor without repairing the problem may cause the monitor to fall or topple over, resulting in injury. Printed in Japan EN(1) -4- -1- Supplied accessories Confirm that the following accessories have been provided with the product. 4 Mount the support rods to the stand. · Mount using the supplied M8 bolts. · The support rods can be mounted at two different heights. Spring washer Plain washer 1500 mm* (59 1/16 inch) 6 Mount the LCD Monitor to the stand (and support rods) using the bolts removed in step 3. Plain washer Spring washer Support rod x 2 M8 bolt x 4 M8 spring washer x 4 M8 plain washer x 4 Left and right base reinforcement angles (x 1 each) Left and right cover mounting Front and rear base plates (x 1 each) Front cover x 1 Extension front cover x 1 Left and right back covers (x 1 each) angles (x 1 each) Cover reinforcement angle x 1 M6 screw x 56 Cable clamp x 4 Operation manual (this manual) 1600 mm* (63 inch) 7 Precautions on use · The installation, removal, or transportation of the LCD Monitor must be performed by qualified service personnel. Installation requires special knowledge and qualifications. · Customers should not attempt to install, remove, or transport the LCD Monitor by themselves. · SHARP shall have no liability for any accidents or damages caused by improper installation or mishandling. *Height to center of the LCD Monitor Confirm that the LCD Monitor is mounted securely, and then remove the hooks of the hoisting device. 5 1 Hoist to the height where the LCD Monitor is to be mounted. n Mounting stand cover Attach the base reinforcement angle (L and R) to the stand of the monitor with 6 supplied M6 screws. Base reinforcement angle [Step 4 continued] · When height is 1600 mm (63 inch) (1) Attach the extension front cover with 4 supplied M6 screws. Extension front cover Installation procedure n Mounting support rods Caution · The LCD Monitor is large and heavy. It must be moved with a hoisting device (chain block, etc. ). [. . . ] · Make sure that the front cover does not scrape against the base plates to prevent scratching. Front cover mounting procedure Fit one side of the front cover over the cover mounting angle (1), then fit the other side while pulling outwards (2, 3, 4). 4 1 3 2 Front cover *Rear side of front cover -2- -3- [. . . ]