User manual SHARP PN-ZT10E

[. . . ] ENGLISH PN-ZT10E 65" Touch Panel OPERATION MANUAL DEUTSCH FRANÇAIS Applicable models (as of March 2007) LCD MONITOR PN-655E Authorised representative responsible for the European Union Community Market SHARP ELECTRONICS (Europe) GmbH Sonninstraße 3, D-20097 Hamburg IMPORTANT INFORMATION WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within a triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. IMPORTANT: To aid reporting in case of loss or theft, please record the product's model and serial numbers in the space provided. [. . . ] This may cause damage or a malfunction. · Check that the clearance between the monitor and the touch panel is not too great. 1. Attach the mounting brackets (supplied) at the two positions on the rear of the touch panel for initial fixing. Attach the mounting brackets in the orientation shown in the illustration. During the initial fixing, secure the brackets so that they are raised at the highest position. Touch panel (rear side) Mounting bracket (supplied) Touch panel (rear side) Mounting screws (supplied) 2. Place the touch panel over the front side of the monitor. Be careful that the touch panel does not hit the monitor. 9 E Preparation (Continued) 3. Lower the mounting brackets from the initial position in step 1 and secure them with screws (2 brackets). 4. Attach the remaining mounting brackets (3 brackets). Caution · Tighten the mounting screws securely using a flat-blade screwdriver. Be careful not to tighten the screws excessively. This may cause distortion of the unit. E 10 Setting up the PC To use the touch panel, you need to connect a PC to the touch panel and install the TouchPanel driver and TouchPanel Setting Program onto the PC. Installing the TouchPanel driver Caution · This procedure requires administrator privilege. · To use a USB hub, select a model supporting bus power. USB hubs supporting self power cannot be used. · Do not connect the USB cable until the OS starts up. · Do not touch the touch panel while connecting the USB cable. It will be detected as a failure of the infrared transmitter/receiver elements, leading to a malfunction. When this occurs, disconnect the USB cable once and then reconnect it. 1. Turn on the monitor and PC to display the PC screen on the monitor. Insert the supplied Utility Disk into the CD-ROM drive of the PC. Connect the PC and touch panel with the USB cable (supplied). To the USB terminal of the PC USB terminal To the USB terminal USB cable (supplied) When the cable is connected, the "Welcome to the Found New Hardware Wizard" screen is displayed. If the message "Can Windows connect to Windows Update to search for software?" appears, select "No, not this time" and click "Next". Select "Install the software automatically" and click "Next". If the message "has not passed Windows Logo testing to verify its compatibility. . . " appears, click "Continue Anyway". [. . . ] When you use the Classic View, double-click "Add or Remove Programs". Select "TouchPanel USB-Serial-V2 Bridge" and click "Change/Remove". The uninstallation process finishes. E 18 Troubleshooting Before calling for repair services, make sure following checks for possible remedies to the encountered symptoms. Problem The touch panel does not respond. Check item Is the USB cable connected properly? [. . . ]