User manual SHARP PN-655E

[. . . ] IMPORTANT The wires in this mains lead are coloured in accordance with the following code: GREEN-AND-YELLOW : Earth BLUE : Neutral BROWN : Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows: · The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safety earth or coloured green or green-and-yellow. The wire which is coloured BLUE must be connected to the terminal which is marked with the letter N or coloured black. The wire which is coloured BROWN must be connected to the terminal which is marked with the letter L or coloured red. ensure that your equipment is connected correctly. [. . . ] INPUT (Input mode selection) Each time you press this button, the mode changes in the following order (see page 8): · dIGITAL ANALOG COMPONENT VIDEO DIGITAL. * If the remote control is not available, you can change the mode by pressing the input switch on the front panel of the monitor with a sharp object (see page 8). Press the MUTE button again to turn the sound back to the previous level. * If you do not press any buttons for about 4 seconds, the VOLUME menu automatically disappears. Sound is muted when volume is set to "0". * If you do not press any buttons for about 4 seconds, the BRIGHT menu automatically disappears. SIZE (Screen size selection) Each time you press this button, the screen size changes in the following order (see page 34): · wIDE ZOOM 1 ZOOM 2 NORMAL DotbyDot WIDE. MODE (Screen mode selection) Each time you press this button, the screen mode changes in the following order: · The display disappears when you press this button again, or it disappears automatically after approximately 4 seconds. Menus can be displayed on the screen to enable video and audio adjustment and the setting of various functions using the remote control unit. For more information, refer to the pages where each topic is explained. Press MENU twice to close the menu screen. The menu screen will close automatically if no operation is performed for about 15 seconds. Yellow: Current setting Blue: Selectable items Grey: Items that cannot be selected * There are various reasons why items cannot be selected, but the main reasons are as follows: · The function is not compatible with the current input signal. Menu screen duration The menu screen will revert to the normal screen if there is no operation for about 15 seconds while the menu screen is displayed. The menu item illustrations in this operation manual are for explanation purposes only and may vary slightly from what is actually displayed. You can return contrast, image quality, and other settings to their factory-preset values, specify whether power LEDs lights, and enable control via RS-232C (see page 37) among other functions. For about 5 seconds, press After initialisation (reset), turn the main power switch off and then back on. [ADJUSTMENT LOCK] Function Specifies whether to lock settings such as ADJUSTMENT and WHITE BALANCE. While locked, the remote control unit cannot perform operations other than turning power on/off (POWER button) and displaying the FUNCTION 1 screen. [LED] Function Specifies whether to light power LEDs. [RS-232C] Function Specifies whether to allow control via RS-232C (see page 37). You can use the adjustment pattern on the supplied CD-ROM to adjust each parameter. [. . . ] solution: · If the monitor enters standby mode due to a rise in temperature, you can reset the monitor to normal operation by turning it on again using the POWER button on the remote control unit or the power switch on the front panel. The monitor, however, will enter standby mode again if the cause of the temperature rise is not eliminated. Check whether the monitor is placed at a location where a quick rise in temperature is likely. Internal temperature rises quickly if the vents on the monitor are blocked. [. . . ]