User manual SHARP PN-TPC1 DATASHEET

[. . . ] This equipment has been tested and found to comply with the limits for Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. [. . . ] An image with a 4:3 aspect ratio is enlarged to fill the entire screen without changing the aspect ratio. Use this size if ZOOM 1 cuts off the subtitles. With a monitor with a screen resolution of 1600 x 1200, selecting DotbyDot displays the NORMAL screen. Using this monitor's screen-size switching or dual-screen display functions to compress or expand the screen for commercial or public viewing in establishments like cafes or hotels may infringe on the rights of the creators, as protected by Copyright Law, so please be careful. When "Enlarge" is set, the screen size is fixed to "WIDE" mode. When dual-screen display is selected, the screen size cannot be changed. The appearance of the original video may change if you select a screen size with a different aspect ratio than the original image (e. When an ordinary non-wide image (4:3) is viewed with the whole screen using the screen-size switching function of this monitor, the edge of the image may be lost or appear distorted. If you wish to respect the creator's intentions, set the screen size to "NORMAL". When playing commercial software, parts of the image (like subtitles) may be cropped. In this case select the optimal screen size using the screen-size switching function of this monitor. Black screens appear from both the top and bottom of the screen, and the displayed image is compressed into the central field. AUDIO OUTPUT Sets the volume of sound output from the PC/AV audio output terminals. 480LINES (PC2/PC3) If a computer connected to the PC2/PC3 input terminal has a resolution of 640 x 480 or 848 x 480, make a selection according to the resolution. 768LINES (PC2/PC3) If a computer connected to the PC2/PC3 input terminal has a resolution of 1024 x 768, 1280 x 768 or 1360 x 768, make a selection according to the resolution. SELF ADJUST On a PC2/PC3 screen with a resolution of 800 x 600 or higher, specify whether to perform screen adjustment automatically or not. When ON is selected, the screen is automatically adjusted when the timing of input signals varies. "ADJUSTING" appears on the screen during the adjustment. POWER MANAGEMENT POWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal standby mode when the PC screen is displayed. MOTION TIME 1 Specify a time period (operating interval) until SCREEN MOTION starts. MOTION TIME 2 Specify a time period during which SCREEN MOTION operates (time period during which the screen will move). SET Assigns ID numbers to monitors connected in a daisy chain (see page 26), using RS-232 cables. [. . . ] You may hear cracking sound from the monitor. This happens when the cabinet slightly expands and contracts according to change in temperature. This does not affect the monitor's performance. When the internal temperature of the monitor rises excessively, the brightness of the backlight decreases automatically in order to prevent high-temperaturerelated problems. [. . . ]