User manual SHARP QA-25

[. . . ] *) Please contact your local authority for further details. It means that used electrical and electronic products should not be mixed with general household waste. There is a separate collection system for these products. If your used electrical or electronic equipment has batteries or accumulators, please dispose of these separately beforehand according to local requirements. [. . . ] Lines will appear on the display when batteries are properly installed. The battery should last approximately one year under normal use. When replacing the batteries, always change both batteries at the same time, and make sure they are the same type. If the remote control does not operate normally after replacing the batteries, press the RESET button using a thin pointed implement. If you will not be using the unit for a prolonged period, remove the batteries from the remote control. Point the remote control towards the units signal receiver window and press the desired button. A beep will sound when the unit receives the signal. Make sure nothing, such as curtains, blocks the signal receiver window. Do not expose the signal receiver window to direct sunlight. This may adversely affect its operation. If necessary, close the curtains to block out the sunlight. Moreover, do not bend the hose at any point, nor allow the end to be submerged in water. The fan speed is preset to AUTO and cannot be changed. )on the unit will turn The unit generates heat during dehumidification mode and the room temperature will rise. Install the exhaust hose if you do not want the room temperature to rise. This will help to slightly drop the room temperature, but dehumidification performance will become less effective than when operating without the exhaust hose. In this mode, the air conditioner simply circulates the air without cooling it. The red OPERATION lamp ( ) on the unit will turn off. Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock. Although the louvers are closed and no air blows out into the room, the external ventilation fan speed changes. The red OPERATION lamp ( ) on the unit will turn off. Install the exhaust hose (See Page 8), turn the drainage nozzle to the CLOSE position, and check the drainage nozzle is covered with the stopcock. [. . . ] 1 Perform drainage to drain out water within the unit. (See Page 17 "When the unit is not used for a long time)". 2 Operate the unit the FAN or VENTILATION mode for about half a day to thoroughy dry inside the unit. If the unit appears to be malfunctioning, check the following points before calling for a service. [. . . ]