User manual SHARP QT-80W

[. . . ] Q Hold the AC power plug by the head when removing it from the AC socket as pulling the lead can damage internal wires. q When cleaning the heads , pinch roller , etc. , remove the AC power lead from the AC socket as the unit contains high voltages. Do not remove the outer cover, as this may result in electric shock. [. . . ] Load a cassette into the cassette compartment with the side to be played facing up. Q Do not use C-120 tapes, or poor-quality tapes, as they may cause malfunctions. Q Before loading a tape into the cassette compartment, tighten the slack with a pen or pencil. q Cassettes have removable tabs that prevent accidental recording or erasing. Removing the tab will protect the corresponding side from being erased. Cover the tab holes with adhesive tape to erase or record again. Precautions: q Be sure not to press the PLAY 0 and REWIND 3 buttons simultaneously, or the tape will become damaged. Q Before changing from one tape operation to another, press the STOP/EJECT s 7 button. Q Do not press the PAUSE 6 button whilst the fast forward or rewind operations are in progress. The F FWD 2 or REWIND 3 button will not be released when the tape end is reached. Before recording: q When recording important selections, make a preliminary test to ensure that the desired material is properly recorded. Q SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. Q The ALC (Automatic Record Level Control) circuit automatically controls the level of the input signal used for recording. Q The VOLUME and X-BASS controls may be adjusted with no effect on the recorded signal. (Variable Sound Monitor) q Metal and CrO2 tapes cannot be used for recording. S Recording from the radio s Recording from the built-in microphone 1 Set the FUNCTION switch to RADIO. 4 Load a blank cassette into the cassette compartment with the side to be record- 4 Press the RECORD q button. 7 Press the PAUSE 6 button again to be- q Recording from the built-in microphone is Beat cancel switch: If a whistling noise occurs when recording from an MW, SW1 or SW2 station, set the BEAT CANCEL switch to A or B, whichever gives the best reception. Q Do not connect anything to the LINE IN and MIXING MIC sockets. 2 Load a tape into the cassette compartment with the side to be erased facing up. [. . . ] Read the demagnetiser's instructions carefully before use. And a diluted soap solution, then wipe with a dry cloth. Caution: q Do not use chemicals for cleaning (petrol, paint thinner, etc. Q Do not apply oil to the inside of the unit. [. . . ]