User manual SHARP QT-CD121H

[. . . ] IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN. DANGER: The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner. Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur. To fit an appropriate plug to the mains lead, follow the instructions below: SERVICE INFORMATION In the unlikely event of your equipment requiring repair, please contact the dealer or supplier from whom it was purchased. Where this is not possible, please contact the telephone number listed below. [. . . ] Using this product with a higher voltage other than which is specified is dangerous and may result in a fire or other type of accident causing damage. SHARP will not be held responsible for any damage resulting from use of this unit with a voltage other than that which is specified. s Battery use q Insert the batteries as shown on the rear panel of the main unit and in the battery compartment of the remote control. q Replace all old batteries with new ones at the same time. q Remove the batteries if they are weak or if the unit will not be used for long periods of time. This will prevent potential damage due to battery leakage. Caution: Do not use rechargeable batteries (nickel-cadmium battery, etc. ). Battery replacement: For the main unit: Replace the batteries when they become weak and/or recording or playback is impaired. This may occur even though radio broadcasts are audible. For the remote control: Replace the batteries if the operating distance is reduced or if the operation becomes erratic. s Care of compact discs Compact discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your CD collection and player. q Do not write on either side of the disc, particularly the non-label side. Signals are read from the non-label side. q Keep your discs away from direct sunlight, heat, and excessive moisture. Fingerprints, dirt, or water on the CDs can cause noise or mistracking. If a CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius. s Condensation Sudden temperature changes, storage or operation in an extremely humid environment may cause condensation inside the cabinet (CD pickup, tape heads, etc. ) or on the transmitter LED on the remote control. Condensation can cause the unit to malfunction. If this happens, leave the power on with no disc (or cassette) in the unit until normal playback is possible (about 1 hour). Wipe off any condensation on the transmitter LED with a soft cloth before operating the unit. s Cassette tape q For playback, use normal or low-noise tape for the best sound. (Metal or CrO2 tape is not recommended. ) For recording, use only normal tape. q Do not use C-120 tapes, tapes with large diameter reels, or poor-quality tapes, as they may cause malfunctions. q Before loading a tape into the cassette compartment, tighten the slack with a pen or pencil. q Cassettes have removable tabs which prevent accidental recording or erasing from taking place. [. . . ] As this product is intended for private domestic use only, the guarantee will not apply if the product is used in the course of a business, trade or profession. 3. To benefit from this guarantee, any fault which occurs must be notified to Sharp, or its appointed Service Facility within one year from the date this product was purchased. Proof of purchase must be provided. 4. The guarantee does not cover carriage costs, jewelled styli, audio tapes, compact discs or batteries. 5. [. . . ]