User manual SHARP QT-CD170H

[. . . ] Make sure you remove the plug from the set and wall socket before inserting batteries. Open the battery compartment and insert six batteries, type R-20, UM-4 or D-cells, (preferably alkaline) with the correct polarity as indicated by the "+" and "-" symbols inside the compartment. Replace the compartment door, making sure the batteries are firmly and correctly in place. ­ If BATT LOW lights up, battery power is running low. [. . . ] ⷠFor MW (AM), LW, the set is provided with a built-in aerial so the telescopic aerial is not needed. Direct the aerial by turning the whole set. Press PRESET 3 or 4 once or more to allocate a number from 1 to 30 to this station. TM Display: PROG disappears, the preset number and the frequency of the preset station are shown. Repeat the above four steps to store other stations. ⷠYou can overwrite a preset station by storing another frequency in its place. In North and South America the frequency step between adjacent channels in the AM and FM band are 10 KHz and 100 KHz respectively. in the rest of the world this step is 9 KHz and 50 KHz. Usually the frequency step has been preset in the factory for your area. TM When you tune to radio stations, the display shows tuning in either steps of 9 or 10. TM All preset stations will be affected and you may need to reprogramme the preset stations. Recording is permissible insofar as copyright or other rights of third parties are not infringed. ⷠThis deck is not suited for recording on CHROME (IEC II) or METAL (IEC IV) type cassettes. For recording, use only NORMAL type cassettes (IEC I) on which the tabs have not been broken. At the very beginning and end of the tape, no recording will take place during the 7 seconds, when the leader tape passes the recorder heads. ⷠTo protect a tape from accidental erasure, have the tape in front of you and break out the left tab. Recording on this side is no longer possible. To record over this side again, cover the tabs with a piece of adhesive tape. Insert a suitable tape into the cassette deck and close the cassette door. ­ Playing of the CD programme starts automatically from the beginning of the programme. It is not necessary to start the CD player separately. To select and record a particular passage within a track · When you recognize the passage you want, release SEARCH or §. [. . . ] To ensure quality recording and playback of the tape deck, clean parts A, B and C shown in the diagram below, after approx. 50 hours of operation, or on average once a month. Use a cotton bud slightly moistened with alcohol or a special head cleaning fluid to clean both decks. Press PLAY 1 and clean the rubber pressure rollers C. [. . . ]