User manual SHARP QT-CD44H

[. . . ] You will then be given details of how to obtain service. - 0345-125387 Please note; all calls will be charged at local rate. Certain replacement parts and accessories may be obtained from our main parts distributor. MANCHESTER 0161-682-1415 READING 01189-876444 IMPORTANT: The wires in the mains lead are coloured in accordance with the following code: Blue Brown : Neutral : Live As the colours of the wires in the mains lead of this product may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: q The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black. [. . . ] Demagnetise these parts once every 30 hours of playing/recording by using a commercial tape head demagnetiser. Read the demagnetiser's instructions carefully before use. s External care q Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then wipe with a dry cloth. q Do not use chemically treated cleaning cloths or other chemicals. 1 QT-CD44H(SUK) TINSE0004SJZZ <P=002> PRECAUTIONS s General q Do not use oil, solvents, petrol, paint thinners or insecticides on the unit. q Do not expose the unit to moisture, to temperatures higher than 60°C (140°F) or to extreme low temperatures. q Keep the unit away from direct sunlight, strong magnetic fields, excessive dust, humidity and electronic/electrical equipment (home computers, facsimiles, etc. ) which generates electrical noise. q Hold the AC power plug by the head when removing it from the AC socket, since pulling the lead can damage internal wires. q When cleaning the heads, pinch roller, etc, remove the AC power plug from the wall socket as the unit contains high voltages. Do not remove the outer cover, as this may result in electric shock. Refer internal service to your local SHARP service facility. q Use the unit on a firm, level surface free from vibration, and do not place anything on the top of the unit. q If the unit does not work properly whilst in use, set the FUNCTION switch to STAND-BY and then to ON again. q Before loading a tape into the cassette compartment, tighten the slack with a pen or pencil. q Cassettes have removable tabs which prevent accidental recording or erasing from taking place. Removing the tab will protect the corresponding side from being erased. Cover the tab holes with adhesive tape to erase or record again. Side A (1) s AC power lead q If the unit will not be used for a long period of time, remove the AC power lead from the AC socket. q Connection of the AC power lead to the unit disconnects the batteries. q Never use a power lead other than the one supplied. Use of a power lead other than the one supplied may cause an electric shock or fire. Tab for side B (2) Tab for side A (1) 2 QT-CD44H(SUK) TINSE0004SJZZ <P=003> AC power Battery power 3 4 2 1 7 8 6 5 q AC 230 - 240 V, 50 Hz q To AC INPUT q 8 "D" size batteries (UM/SUM-1, R20, HP-2 or similar) q When inserting or removing the batteries { and , push them towards the battery terminals. q Installing the batteries incorrectly may cause the unit to malfunction. ë Remote control q 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar) Remote Sensor q Batteries are not included. 15 15 0. 2 m - 6 m (8" - 20') Notes concerning use: q Replace the batteries if the operating distance is reduced or if the operation becomes erratic. q Periodically clean the transmitter LED on the remote control and the sensor on the main unit with a soft cloth. q Exposing the sensor on the main unit to strong light may interfere with operation. Change the lighting or the direction of the unit. [. . . ] q General Power source: AC 230 - 240 V, 50 Hz DC 12 V ["D" size (UM/SUM-1, R20 or HP-2) battery × 8] Power consumption: 11 W Output power: MPO (Max. ); 8. 4 W (4. 2 W + 4. 2 W) (AC operation) RMS; 4. 6 W (2. 3 W + 2. 3 W) (DC operation, 10 % T. H. D. ) Speakers: 10 cm (4") full-range speaker x 2 Tweeter × 2 Output Headphones; 16-50 ohms terminal: (recommended; 32 ohms) Dimensions: Width; 480 mm (18-15/16") Height; 153 mm (6-1/16") Depth; 254 mm (10") Weight: 3. 2 kg (7. 1 lbs. ) without batteries q Tape recorder Frequency response: Signal/noise ratio: Wow and flutter: Motor: Bias system: Erase system: 50 - 14, 000 Hz (Normal tape) 50 dB 0. 25 % (WRMS) DC 12 V electric governor AC bias Magnet erase q Compact disc player Type: Signal readout: Audio channels: Quantization: Filter: D/A converter: Wow and flutter: Compact disc Non-contact, 3-beam semiconductor laser pickup 2 16-bit linear quantization 4-times oversampling digital filter 1-bit D/A converter Unmeasurable (less than 0. 001% W. peak) q Radio Frequency range: FM; 87. 5 - 108 MHz AM; 526. 5 - 1, 606. 5 kHz 8 QT-CD44H(SUK) TINSE0004SJZZ TERMS OF GUARANTEE Sharp Electronics (UK) Ltd. ("Sharp") guarantees to provide for the repair, or at its option the replacement, of this product subject to the conditions listed below:- 1. This guarantee shall only apply to faults which are due to inferior workmanship or materials. It does not cover faults or damage caused by accident, misuse, fair wear and tear, neglect, tampering with the product, or repair other than by a Service Facility appointed by Sharp. 2. [. . . ]